ISO/IEC DIS 61400-4-2023 PDF

ISO/IEC DIS 61400-4-2023 PDF

Wind energy generation systems-Part 4: Design requirements for wind turbine gearboxes

$48.00 $96.00 -50%
Product Code: ISO/IEC DIS 61400-4
Stock In Stock
Edition: 23#
Published: 09/22/2023
Number of Pages: 95
File Size: 1 file, 2.2 MB

Available Options

Product Description

Wind energy generation systems — Part 4: Design requirements for wind turbine gearboxes

Introduction: IEC 61400-4 outlines minimum requirements for specification, design, and verification of gearboxes in wind turbines. It does not serve as a complete design specification or instruction manual. It is intended for use by experienced designers of wind turbine drivetrains, gearboxes, and gears or bearings who are capable of selecting reasonable values for the design factors, based on knowledge of similar designs and the effects of such items as lubrication, deflection, manufacturing tolerances, metallurgy, residual stress, and system dynamics. Any of the requirements of this standard may be altered: if more accurate data are available from full scale load tests, precise measurements, comprehensive mathematical analysis, or any combination of these; or on the basis of proven operating experience; or the evidence is accessible for independent assessment (e.g. by an accredited renewable energy certification body); and the accuracy and reliability of the alternative method is demonstrated with respect to the safety and reliability of the complete wind turbine drive system. IEC/DIS 61400-4:2023(E) © IEC 2023 – All rights reserved

Scope: This part of the IEC 61400 series is applicable to enclosed speed increasing gearboxes for horizontal axis wind turbine drivetrains with a power rating in excess of 500 kW. This standard applies to newly designed gearboxes for wind turbines installed onshore or offshore. The technical requirements given in this standard are not intended for repaired or refurbished gearboxes, or for the extension of the service life beyond the design life. This International Standard provides requirements and guidance on the analysis of the wind turbine loads in relation to the design of the gear and gearbox elements. The gearing elements covered by this standard include such gears as spur, helical or double helical and their combinations in parallel and epicyclic arrangements in the main power path. This standard does not apply to power take off (PTO) gears. This standard includes requirements, design recommendations, and rating of gearboxes with rolling bearings, plain bearings, or combinations of both bearing types. Also included are requirements and guidance on the engineering of shafts, shaft hub interfaces, lubrication, wind turbine controller interface, and the gear case structure to accomplish a design that is capable to withstand the environment and operating conditions of a wind turbine. Requirements for dynamic analysis of the gearbox within the wind turbine system are specified for the purpose of identifying load levels exceeding the predictions of the global aeroelastic simulation. The analysis of noise transmission and emission (e.g. tonal emission at gear mesh frequencies) is not within the scope of this document. Further, this International Standard provides requirements and guidance on gearbox design verification, prototype testing and production testing, as well as consideration of design for service and maintenance. Requirements and guidance for a systematic assessment of the design reliability of a gearbox design under reference operating conditions are given in IEC/TS 61400-4-1. This International Standard is supported by two Technical Reports: IEC/TR 61400-4-2 provides additional information on lubrication of wind turbine drivetrains and IEC/TR 61400-4-3 con

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • Introduction

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO/IEC DIS 61400-4-2023 PDF

ISO/IEC DIS 61400-4-2023 PDF

$48.00 $96.00