Information technology – Sensor network – Guidelines for design in the aeronautics industry: active air-flow control
Introduction: The number of wireless connections is growing exponentially around the world. Wireless communications are expanding to areas previously reluctant to use this type of technology. In the field of aeronautics, wireless intra-avionics applications are just recently gaining acceptance both in industrial and academic arenas. This late adoption is mainly because wireless transmissions have been conventionally associated with reliability and interference issues. Aeronautics applications on board aircraft are highly critical and therefore the inherent randomness of wireless technologies created lots of skepticism, particularly for sensing, monitoring and control of critical aeronautical subsystems. In addition, uncontrolled wireless transmissions can potentially create interference to other aeronautical subsystems, thus leading to malfunctions and unsafe operation. However, recent interference and reliability studies with state-of-the-art wireless standards suggest safe operation and thus the feasibility of a relatively new research area called wireless avionics intra-communications (WAICs). In the last few years, wireless technology has started to be used on board for systems that conventionally used only wire-line infrastructure (i.e., as replacement of cables). It is also being used for applications which are now only possible thanks to the wireless component (e.g., indoor localization, tracking and wireless power transfer). Examples of potential applications of wireless avionics i
Scope: This document describes the concepts, issues, objectives, and requirements for the design of an active air-flow control (AFC) system for commercial aircraft based on a dense deployment of wired/wireless sensor and actuator networks. The objective of this AFC system is to track gradients of pressure across the surface of the fuselage of aircraft. This collected information will be used to activate a set of actuators that will attempt to reduce the skin drag effect produced by the separation between laminar and turbulent flows. This will be translated into increased lift-off forces, higher vehicle speeds, longer ranges, and reduced fuel consumption. The document focuses on the architecture design, module definition, statement of objectives, scalability analysis, system-level simulation, as well as networking and implementation issues using standardized interfaces and service-oriented middleware architectures. This document aims to serve as guideline on how to design wireless sensor and actuator networks compliant with ISO/IEC 29182.
Contents:
- FOREWORD
- INTRODUCTION
- Scope