ISO 10042-2018 PDF

ISO 10042-2018 PDF

Welding - Arc-welded joints in aluminium and its alloys - Quality levels for imperfections

$71.50 $143.00 -50%
Product Code: ISO 10042
Stock In Stock
Edition: 3RD
Published: 06/2018
Number of Pages: 26
File Size: 1 file, 961 Bytes

Available Options

Product Description

Welding - Arc-welded joints in aluminium and its alloys - Quality levels for imperfections

Introduction: This document is intended to be used as a reference in drafting application codes and/or other application standards. It contains a simplified selection of arc welding imperfections based on the designations given in ISO 6520-1. Some imperfections described in ISO 6520-1 have been used directly while others have been grouped together. The basic numerical referencing system from ISO 6520-1 has been used. The purpose of this document is to define the dimensions of typical imperfections which can be expected in normal fabrication. It can be used within a quality system for the production of welded joints. It provides three sets of dimensional values from which a selection can be made for a particular application. The quality level necessary in each case needs to be defined by the application standard or the responsible designer, in conjunction with the manufacturer, user and/or other parties concerned. The quality level are prescribed before the start of production, preferably at the enquiry or order stage. For special purposes, additional details can be necessary. The quality levels given in this document provide basic reference data and are not specifically related to any particular application. They refer to the types of welded joint in fabrication and not to the complete product or component itself. It is possible, therefore, that different quality levels are applied to individual welded joints in the same product or component. It is normally be expected that, for a particul

Scope: This document specifies quality levels for imperfections in arc-welded joints in aluminium and its alloys. It applies to material thicknesses above 0,5 mm. Three quality levels are given in order to permit application to a wide range of welded constructions. They are designated by symbols B, C and D. Quality level B corresponds to the highest requirement on the finished weld. The quality levels refer to production quality and not to the fitness for purpose (see 3.2) of the product manufactured. This document is applicable to all types of welds (e.g. butt welds, fillet welds and branch connections), to manual, mechanized and automated welding, and to all welding positions. It is applicable to the following welding processes: — metal inert gas welding (MIG welding); gas metal arc welding /USA; — tungsten inert gas welding (TIG welding); gas tungsten arc welding /USA; — plasma arc welding. It is not applicable to metallurgical aspects (e.g. grain size, hardness).

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 10042-2018 PDF

ISO 10042-2018 PDF

$71.50 $143.00