ISO 10093-2020 PDF

ISO 10093-2020 PDF

Plastics-Fire tests-Standard ignition sources

$60.00 $120.00 -50%
Product Code: ISO 10093
Stock In Stock
Edition: 3RD
Published: 12/2020
Number of Pages: 44
File Size: 1 file, 3 Bytes

Available Options

Product Description

Plastiques - Essais au feu - Sources d’allumage normalisées

Introduction: Fires are caused by a wide range of possible ignition sources. Statistical analysis of fires has identified the major primary and secondary sources, especially for fires in buildings. The most frequent sources of fires have been found to be as follows: a) cooking appliances; b) space-heating appliances; c) electric wiring, connectors and terminations; d) other electrical appliances (such as washing machines, bedwarmers, televisions, water heaters); e) cigarettes; f) matches and smokers' gas lighters; g) blow-lamps, blow-torches and welding torches; h) rubbish burning; and i) candles. This list covers the major primary ignition sources for accidental fires. Other sources can be involved in fires raised maliciously. Research into causes of fires has shown that primary ignition sources (e.g. glowing cigarettes or dropped flaming matches) can set fire to waste paper, which then acts as a secondary ignition source of greater intensity. When analysing and evaluating the various ignition sources for applications involving plastics materials, it is important to answer the following questions on the basis of detailed fire statistics. 1) What is the significance of the individual ignition sources in various fire risk situations? 2) What proportion is attributable to secondary ignition sources? 3) Where does particular attention have to be paid to secondary ignition sources? 4) To what extent are different ignition sources responsible for fatal fire accidents? The laboratory ignition so

Scope: This document describes and classifies a range of laboratory ignition sources for use in fire tests on plastics and products consisting substantially of plastics. These sources vary in intensity and area of impingement. They are suitable for use to simulate the initial thermal abuse to which plastics are potentially exposed in certain actual fire risk scenarios. This compilation of standard ignition sources describes the ignition sources used by different standards development organizations and contained in standard test methods, specifications, or regulations used to assess the fire properties or plastics and of products containing plastic materials. The ignition sources described in this document are associated with flaming and non-flaming ignition. This document describes the relevant ignition sources and references the associated standard. This compilation of ignition sources does not discuss the application of the standard referenced in any specific clause in which the ignition source is described, and this compilation is likely not to be a fully comprehensive list of ignition sources. This document does not address detailed test procedures.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 10093-2020 PDF

ISO 10093-2020 PDF

$60.00 $120.00