Optique et photonique - Indications sur les dessins pour éléments et systèmes optiques - Partie 5: Tolérances de forme de surface
Introduction: This document refers to deviations in the form (shape) of an optical surface and provides a means of specifying tolerances for certain types of surface form deviation in terms of nanometres. As it is common practice to measure the surface form deviation interferometrically as the wavefront deformation caused by a single reflection from the optical surface at normal (90° to surface) incidence, it is possible to describe a single definition of interferometric data reduction that can be used in both cases, i.e. in surface form deviation as well as wavefront deformation. As the analysis of most measurements is software based, the deviations are expressed in nanometres. Interferometric measurements, however, use the unit “fringe spacings”. One “fringe spacing” is equal to a surface form deviation that causes a deformation of the reflected wavefront of one wavelength. A value expressed in nanometres is an indication of the actual height deviation of the surface itself (and not that of the reflected wavefront). The surface under test, together with the test glass is, for example, such an interferometer. The surface form deviation is represented by the wavefront deformation that is the difference between the wavefront reflected by the actual surface and that reflected by the test glass surface. Due to the potential for confusion and misinterpretation, nanometres rather than fringe spacings are to be used. Where fringe spacings are used as units, the wavelength is also to be specified
Scope: This document specifies rules for indicating the tolerance for surface form deviation, in the ISO 10110 series, which standardizes drawing indications for optical elements and systems. NOTE The terminology of interferometry employing the unit “fringe spacings” is widely used for the specification of tolerances. However, the usage of non-interferometric methods for testing of optical parts has recently become more important. Therefore, unlike in the earlier versions of this document, nanometres are now the preferred and standard unit to express surface form deviations. The usage of fringe spacings is still permitted, provided that the base wavelength is explicitly stated. This document applies to surfaces of plano, spherical, aspheric, cylindric, and toric form as well as to surfaces of other non-spherical shape such as generally described surfaces. It also applies to the substrates of diffractive surfaces; for transmitted or reflected wavefront specifications see ISO 10110-16 and ISO 10110-14.