Transportable gas cylinders - Cylinder valves - Specification and type testing
Introduction: This document has been written so that it is suitable to be referenced in the UN Model Regulations. The term “pressure receptacle” is used within this document to cover instances where no differentiation is necessary between gas cylinders, bundles of cylinders, pressure drums and tubes. In this document, the unit bar is used, due to its universal use in the field of technical gases. It should, however, be noted that bar is not an SI unit, and that the corresponding SI unit for pressure is Pa (1 bar = 105 Pa = 105 N/m2). Pressure values given in this document are given as gauge pressure (pressure exceeding atmospheric pressure) unless noted otherwise. Any tolerances given in this document include measurement uncertainties. © ISO 2024 – All rights reserved
Scope: This document specifies design, type testing and marking requirements for: a) cylinder valves intended to be fitted to refillable transportable gas cylinders; b) main valves (excluding ball valves) for bundles of cylinders; c) cylinder valves or main valves with integrated pressure regulator (VIPR); NOTE 1 This includes the following specific VIPR designs where: 1) The pressure regulating system is acting as the primary valve operating mechanism (VIPR type B). This also includes designs where closure of the primary valve operating mechanism is obtained by closing the seat of the pressure regulating mechanism. 2) The primary valve operating mechanism is located at the low-pressure side of the pressure regulating system (VIPR type C). d) valves for pressure drums and tubes; which convey compressed, liquefied or dissolved gases. NOTE 2 Where there is no risk of ambiguity, cylinder valves, main valves, VIPRs and valves for pressure drums and tubes are addressed with the collective term “valves” within this document. This document does not apply to — valves for cryogenic equipment, portable fire extinguishers and liquefied petroleum gas (LPG); — quick-release cylinder valves (e.g. for fire-extinguishing, explosion protection and rescue applications) - requirements for quick-release cylinder valves are specified in ISO 17871 which contains normative references to this document; — self-closing cylinder valves and ball valves. NOTE 3 Requirements for valves for cryogenic vessels are specified in ISO 21011 and at a regional level, e.g. in EN 1626. Requirements for LPG valves are specified in ISO 14245 or ISO 15995. Requirements for self-closing cylinder valves are specified in ISO 17879. Requirements for ball valves are specified in ISO 23826. Requirements for valves for portable fire extinguishers at a regional level are specified, for example, in the EN 3 series. This document only covers the function of a valve as a closure. Other functions that are possibly integrated in the valve can be covered by other standards. Such standards do however not constitute requirements according to this document. NOTE 4 Definition of and specific requirements for VIPRs in addition to