ISO 10327-2014 PDF

ISO 10327-2014 PDF

Air cargo - Main deck containers - Design and testing

$96.50 $193.00 -50%
Product Code: ISO 10327
Stock In Stock
Edition: 2ND
Published: 05/01/2014
Number of Pages: 32
File Size: 1 file, 1 Byte

Available Options

Product Description

Air cargo - Main deck containers - Design and testing

Introduction: The basic functions of main deck air cargo containers are a) the unitization of cargo during ground handling and transportation, and b) the restraint of their contents against accelerations encountered in flight. Throughout this International Standard, the minimum essential criteria are identified by use of the key word “shall”. Recommended criteria are identified by use of the key word “should” and, while not mandatory, are considered to be of primary importance in providing safe, economical, and usable air transport containers. Deviation from recommended criteria should only occur after careful consideration and thorough service evaluation have shown alternate methods to provide an equivalent level of safety. The requirements of this International Standard are expressed in the applicable SI units, with approximate inch-pound units conversion between brackets for convenience in those countries using that system. Where it is deemed necessary to use exact values, the SI unit ones are to be used. Per exception, the exact figures are those in inches for container base overall outside dimensions. © ISO 2014 – All rights reserved

Scope: 1.1 This International Standard covers the minimum design and operational testing requirements for general purpose, base-restrained containers exclusively intended for the main or upper deck cargo compartments of main line civil transport aircraft, capable of being used by either airlines or shippers and requiring an airworthiness authority approval (certification). NOTE 1 The metric equivalents for dimensions have been rounded up or down to the nearest millimetre, except in critical dimensions. Masses have been rounded up to the nearest kilogram and forces have been rounded up to the nearest 10 N. NOTE 2 Though nothing technically prevents their being used for baggage, main deck containers are generally used only for carriage of freight. 1.2 This International Standard does not cover the performance requirements and ultimate load testing parameters for airworthiness authorities approval (certification), which are covered in ISO 21100 or, for units approved prior to 2012, ISO 8097:2001. The design and operational testing requirements of this International Standard are additional to the performance and certification testing requirements of these International Standards. 1.3 This International Standard does not cover containers with an overall height of 1 625 mm (64 in) or less, that can be loaded on the lower deck compartments of main line civil transport aircraft, which are specified in ISO 6517, nor air-surface main deck containers, which are specified in ISO 4128 and ISO 8323.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 10327-2014 PDF

ISO 10327-2014 PDF

$96.50 $193.00