Véhicules routiers - Méthodes d'essai des perturbations électriques provenant de décharges électrostatiques
Introduction: The electrostatic discharge, due to former charge build-ups generated, for example, when moving about inside a vehicle or getting out of it, has assumed greater significance with the increase of vehicle electronic modules. Tests simulating the electrostatic discharge of humans, in common use by various industries, were examined and it was determined that they were not fully applicable to the automotive environment. As a consequence, tests tailored to the automotive environment were developed. Tests that simulate an electrostatic discharge (ESD) into a vehicle electrical system are based on the human ESD model. Sensitive electrical devices can be adversely affected by energy either coupled or radiated from electrostatic discharges. This document describes ESD tests that are applicable to both automotive electronic modules and vehicles. © ISO 2023 – All rights reserved
Scope: This document specifies the electrostatic discharge (ESD) test methods necessary to evaluate electronic modules intended for vehicle use. It applies to discharges in the following cases: — ESD in assembly; — ESD caused by service staff; — ESD caused by occupants. This document describes test procedures for evaluating both electronic modules on the bench and complete vehicles. This document applies to all types of road vehicles regardless of the propulsion system (e.g. spark-ignition engine, diesel engine, electric motor). The test for electronic modules on the bench described in this document applies to any DUT (powered by an unshielded power system, DUT powered by a shielded power system, self-powered DUT, etc.). This document does not apply to pyrotechnic modules.