Hexalobular internal driving feature for bolts and screws
Scope: This International Standard specifies the shape and basic dimensions of the hexalobular internal driving feature for bolts and screws, including the gauging method. The curvature of the contour of the hexalobular internal driving feature is defined by the gauges specified in Tables 3, 4, and 5. Additional information which can be used when drawing the contour is given in Annex A. The intent of this International Standard is to provide the details necessary for inspection of the hexalobular driving feature. It is not suitable for, nor intended to be used as, a manufacturing standard. 2 Basic dimensions See Figure 1 and Table 1. Counterbore: c ≤ 0,13 mm up to socket no. 15 c ≤ 0,25 mm over socket no. 15 Penetration depth, t: see relevant product standard. See Table 2. NOTE The contour of the bottom of the socket beyond the gauge is at the option of the manufacturer. Figure 1 — Basic dimensions © ISO 2014 – All rights reserved ISO 10664:2014(E) Table 1 — Basic dimensions Dimensions in millimetres Hexalobular socket no. Nominal dimensionsa 0,9 0,6 1,0 0,7 1,2 0,85 1,35 1,0 1,5 1,1 1,75 1,27 2,1 1,5 2,4 1,75 2,6 1,9 2,8 2,05 3,35 2,4 3,95 2,85 4,5 3,25 5,1 3,68 5,6 4,05 6,75 4,85 7,93 5,64 8,95 6,45 11,35 8,05 13,45 9,6 15,7 11,2 17,75 12,8 20,2 14,4 22,4 The curvature of the contour of the hexalobular internal driving feature is defined by the gauges specified in Tables 3, 4, and 5. 3 Gauging 3.1 Principle The hexalobular internal driving feature shall allow the GO gauge (see 3.2) to enter freely to the penetration depth, t, as specified in the relevant product standards. The NO GO gauges (see 3.3.1 and 3.3.2) shall not enter the hexalobular internal driving feature to a depth greater than the fallaway allowance specified in Table 2. 2 © ISO 2014 – All rights reserved