Vibration-generating machines — Guidance for selection — Part 2: Equipment for dynamic structural testing
Introduction: A proper selection of vibration generating system, when purchasing new test equipment or updating existing equipment for the purposes of a specific test or when choosing between the equipment proposed by a test laboratory or even selecting a laboratory which offers its service to carry out such a test, is very important. When making this type of selection, several factors should be considered simultaneously, as follows: — the type of the test to be carried out (e.g. environmental testing, normal and/or accelerated, dynamic structural testing, diagnosis, calibration, etc.); — the motions to be generated during the test; — the test conditions (e.g. single or multiple excitations, one mode of vibration or combined vibration, single or combined test, for example, dynamic plus climatic, etc.); — the objects to be tested and their mounting. This document deals only with equipment intended to be used for dynamic structural testing, and selection procedures are predominantly designed to meet the requirements of this testing. However, specific test conditions and the specific object to be tested can significantly influence the selection. If the equipment is expected to be used for different types of tests, all possible applications should be accounted for when selecting. Thus, if the vibration generator is acquired to be applied during both environmental and dynamic structural testing, ISO 10813-1 and this document should be used simultaneously. In this document, it is presumed that a
Scope: This document provides guidance to select a vibration generator that will be used to evaluate frequency responses of a test structure or to study how vibration grows/decreases along the structure. These structural dynamics tests can be carried out under field or laboratory conditions (see the ISO 7626 or ISO 10846[4][5][6][7] series). This document describes the selection procedure in terms of the force developed by a single vibration generator. Meanwhile, to move massive structures such as dams or bridges, an assembly of vibration generators is usually applied. Properly phased generators produce in total the same force as calculated for a single vibration generator (see 6.2.6). Guidance also can be applied for the selection of equipment to be used for modal testing to determine natural frequencies, modal shapes and damping in a structure; however, for such a test, more factors than covered by this document usually need to be considered. This document deals only with translational excitation. For equipment applied to generate angular vibration, see Reference [8].