Vibration generating machines — Guidance for selection — Part 4: Equipment for multi-axial environmental testing
Introduction: Selection of a suitable vibration generating system is an urgent problem as one needs to purchase new test equipment or to update the equipment already at one's disposal to perform a certain test or to choose from among the equipment proposed by a test laboratory or even a laboratory itself which offers its service to carry out such a test. A problem like this can be resolved only if a number of factors are considered simultaneously, as follows: — type of test to be carried out (environmental testing, normal and/or accelerated, dynamic structural testing, diagnosis, calibration, etc.); — requirements to be followed; — test conditions (single or multiple excitation, one mode of vibration or combined vibration, single or combined test, for example, dynamic plus climatic, etc.); — objects to be tested. This document deals only with equipment to be used for multi-axial environmental testing, and procedures of the selection are predominant to meet the requirements of this testing. Because the multi-axial environmental test system is composed of more than one exciter, ISO 10813-1 should be used along with this document to select the proper exciters. It is presumed in this document that the system to be selected will be able to drive the object under test up to a specified level. In order to generate an excitation without undesired motions, a suitable control system should be used, however selection of a control system lays beyond the scope of this document. It should be emphasized
Scope: This document gives guidance for the selection of vibration generating equipment for multi-axial environmental testing, depending on the test requirements. Multi-axial environmental test equipment dealt with in this document refers to a vibration test system having controlled vibration of more than one degree of freedom, including linear vibration and angular vibration. In this document, one or more exciter per desired degree of freedom is supposed. The guidance covers such aspects of selection as — number, type and models of exciters, — number, type and models of connectors, — system configuration, and — some components.