Rough-terrain trucks — Safety requirements and verification — Part 1: Variable-reach trucks
Introduction: This document is a type-C standard as stated in ISO 12100. This document is of relevance, in particular, for the following stakeholder groups representing the market players with regard to machinery safety: — machine manufacturers (small, medium and large enterprises); — health and safety bodies (regulators, accident prevention organisations, market surveillance etc.) Others can be affected by the level of machinery safety achieved with the means of the document by the above-mentioned stakeholder groups: — machine users/employers (small, medium and large enterprises); — machine users/employees (e.g. trade unions, organizations for people with special needs); — service providers, e. g. for maintenance (small, medium and large enterprises); — consumers (in case of machinery intended for use by consumers). The above-mentioned stakeholder groups have been given the possibility to participate at the drafting process of this document. The machinery concerned and the extent to which hazards, hazardous situations or hazardous events are covered are indicated in the Scope of this document. When requirements of this type-C standard are different from those which are stated in type-A or type-B standards, the requirements of this type-C standard take precedence over the requirements of the other standards for machines that have been designed and built according to the requirements of this type-C standard. This document has been developed in order to align as far as possible its requireme
Scope: This document specifies general safety requirements for non-slewing, rough-terrain variable-reach trucks (referred to as trucks), with rigid chassis and equipped with a telescopic lifting means (pivoting boom) on which a load-handling device such as a carriage with fork arms is typically fitted. Fork arms and other integrated attachments are considered to be parts of the truck. NOTE These trucks are also known as telehandlers, or telescopic handlers. For the purpose of this document, trucks are designed to transport, lift and place loads and can be driven on unimproved terrain. They can also be equipped with a variety of attachments or interchangeable equipment (e.g. fork arms, bale spikes, mowers, sweepers) which can be both load-carrying and non- load-carrying. Other standards, in addition to the relevant provisions of this document, can apply to the attachments. This document is not applicable to the following: a) industrial variable-reach trucks covered by ISO 3691-2; b) machines designed primarily for earth moving, such as loaders, even if their buckets are replaced by fork arms (see ISO 20474-3); c) trucks with articulated chassis; d) machines designed primarily with variable-length load suspension elements (e.g. chain, ropes) from which the load can swing freely in all directions (mobile cranes); e) trucks fitted with personnel/work platforms, designed to move persons to elevated working positions; f) trucks designed primarily for container handling. The significant hazards covered by this document are listed in Annex A. This document does not address hazards that can occur: — during manufacture; — when handling suspended loads, which can swing freely (see ISO 10896-4); — when using trucks on public roads; — when operating in potentially explosive atmospheres; — with a battery, LPG or hybrid as the primary power source. INTERNATIONAL STANDARD ISO 10896-1:2020(E) © ISO 2020 – All rights reserved ISO 10896-1:2020(E) 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references,