ISO 10968-2020 PDF

ISO 10968-2020 PDF

Earth-moving machinery-Operator's controls

$60.00 $120.00 -50%
Product Code: ISO 10968
Stock In Stock
Edition: 3RD
Published: 05/2020
Number of Pages: 42
File Size: 1 file, 3 Bytes

Available Options

Product Description

Earth-Moving Machinery - Operator´s Controls

Introduction: This document specifies design criteria for operator's controls on earth-moving machinery. As machines have gone through significant developments since the first edition of this document in 1995, this document covers both legacy machines and state-of-the-art solutions. This is important to take into account when reading the annexes. As attachments and controls are becoming more advanced, it was considered important to reorganize the document for easier interpretation whereby base machine, equipment and attachments were separated in different annexes. As graders and dozers often have unique operator's controls, it was also decided to separate these two machine types into separate annexes. Other important changes made in the third edition include the removal of minimum and normal actuating forces for operator's controls. It was considered that as there is a large variation in actuating forces for different types of controls, providing standardized actuating forces was not feasible. Instead, it is the manufacturer's responsibility that minimum actuating forces are enough to prevent inadvertent activation of the operator's controls caused by machine operation (e.g. machine acceleration/ deceleration, vibration). While preparing this document, it was noted that levers are developing rapidly and there are large differences even within a given machine family, for example excavators. The document therefore tries to also account for the most advanced excavators, whereby more controls

Scope: This document specifies requirements and guidelines for the operator’s controls on earth-moving machinery as defined in ISO 6165, in as far as those controls relate to any direct-control machine. The recommendations given for finger-, hand- and foot-operated controls are not intended to prevent usage of other types of controls, control locations or control movements. This document is not applicable to devices which are not directly related to machine control. NOTE For remote operator control of machines, see ISO 15817.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 10968-2020 PDF

ISO 10968-2020 PDF

$60.00 $120.00