Test conditions for die sinking electro-discharge machines (die sinking EDM) - Testing of the accuracy - Part 2: Double-column machines (slide-head type)
Introduction: The purpose of this part of ISO 11090 is to standardize methods of testing normal accuracy and general- purpose die sinking electro-discharge machines (die sinking EDM). In this part of ISO 11090, the tolerances for G1, G2, G3, G5, P1, P2, P3, and P4 have been changed from those in ISO 11090-2:1998. The machine axis designations are changed from ISO 11090-2:1998 to comply with ISO 841:2001. Cross-slide table type machines (ISO 11090-2:1998, 3.2) are deleted due to their limited availability in today’s market. The following tests in ISO 11090-2:1998 are deleted due to the limited availability of the reference T-slot in typical machines in today’s market: G9 (checking of straightness of the reference T-slot or reference surface of the table) and G10 (checking of parallelism between the reference T-slot or reference surface of the table and the x-axis motion). © ISO 2014 – All rights reserved
Scope: This part of ISO 11090 specifies, with reference to ISO 230-1 and ISO 230-2, geometric and machining tests and tests for checking accuracy and repeatability of numerically controlled positioning axes for normal accuracy and general-purpose die sinking electro-discharge machines (die sinking EDM). It also specifies the applicable tolerances corresponding to the above-mentioned tests. This part of ISO 11090 is applicable to double-column machines of slide-head type. This part of ISO 11090 deals only with the verification of accuracy of the machine. It does not apply to the testing of the machine operation (vibrations, abnormal noises, stick-slip motion of components, etc.) or to the checking of its characteristics (such as speeds, feeds, etc.), which should generally be checked before the testing of the accuracy. This part of ISO 11090 provides the terminology used for the principal components of the machine and the designation of the axes with reference to ISO 841:2001. NOTE In addition to the terms used in the official ISO languages (English and French), Annex A of this part of ISO 11090 gives the equivalent terms in the Dutch, German, Italian, Swedish, Persian, and Japanese languages. These are published under the responsibility of the national member bodies for Netherlands (NEN), Germany (DIN), Italy (UNI), Sweden (SIS), Iran (ISIRI), and Japan (JISC). However, only the terms given in the official languages can be considered as ISO terms.