Lasers et équipements associés aux lasers - Méthodes d'essai des largeurs du faisceau, angles de divergence et facteurs de limite de diffraction - Partie 1: Faisceaux stigmatiques et astigmatiques simples
Introduction: The propagation properties of every laser beam can be characterized within the method of second order moments by ten independent parameters (see ISO/TR 11146-3). However, due to their higher symmetry most laser beams of practical interest need fewer parameters for a complete description. Most lasers of practical use emit beams which are stigmatic or simple astigmatic because of their resonator design. This document describes the measurement methods for stigmatic and simple astigmatic beams while ISO 11146-2 deals with the measurement procedures for general astigmatic beams. For beams of unknown type the methods of ISO 11146-2 are applicable. Beam characterization based on the method of second order moments as described in both parts is only valid within the paraxial approximation. The theoretical description of beam characterization and propagation as well as the classification of laser beams is given in ISO/TR 11146-3, which is a Technical Report and describes the procedures for background subtraction and offset correction. In this document, the second order moments of the power (energy) density distribution are used for the determination of beam widths. However, there may be problems experienced in the direct measurement of these quantities in the beams from some laser sources. In this case, other indirect methods of the measurement of the second order moments may be used as long as comparable results are achievable. In ISO/TR 11146-3, three alternative methods for beam wid
Scope: This document specifies methods for measuring beam widths (diameter), divergence angles and beam propagation ratios of laser beams. This document is only applicable for stigmatic and simple astigmatic beams. If the type of the beam is unknown, and for general astigmatic beams, ISO 11146-2 is applicable.