ISO 11297-2-2018 PDF

ISO 11297-2-2018 PDF

Plastics piping systems for renovation of underground drainage and sewerage networks under pressure - Part 2: Lining with continuous pipes

$60.00 $120.00 -50%
Product Code: ISO 11297-2
Stock In Stock
Edition: 1ST
Published: 02/2018
Number of Pages: 16
File Size: 1 file, 467 Bytes

Available Options

Product Description

Plastics piping systems for renovation of underground drainage and sewerage networks under pressure - Part 2: Lining with continuous pipes

Introduction: This document is part of a system standard for plastics piping systems of various materials used for renovation of existing pipelines in a specified application area. System standards for renovation dealing with the following applications are either available or in preparation: — ISO 11296, Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks; — ISO 11297, Plastics piping systems for renovation of underground drainage and sewerage networks under pressure (this application); — ISO 11298, Plastics piping systems for renovation of underground water supply networks; — ISO 11299, Plastics piping systems for renovation of underground gas supply networks. These system standards are distinguished from system standards for conventionally installed plastics piping systems by the requirement to verify certain characteristics in the “as installed” condition, after site processing. This is in addition to verification of characteristics of plastics piping systems “as manufactured”. Each of the system standards comprises a: — Part 1: General and all applicable renovation technique family-related parts, which for drainage and sewerage networks under pressure include or potentially include the following: — Part 2: Lining with continuous pipes (this document) — Part 3: Lining with close-fit pipes — Part 4: Lining with cured-in-place pipes — Part 5: Lining with discrete pipes — Part 6: Lining with adhesive-backed hoses The requirements for any given

Scope: This document, in conjunction with ISO 11297-1, specifies requirements and test methods for pipes and fittings which are part of plastics piping systems installed as continuous pipes in the renovation of underground drainage and sewerage networks under pressure. It is applicable to polyethylene (PE) pipes of three different types: — PE solid wall single layered pipes (nominal outside diameter, dn), including any identification stripes; — PE pipes with co-extruded layers on either or both the outside and inside of the pipe (total outside diameter, dn), as specified in Annex A, where all layers have the same MRS rating; — PE coated pipes (outside diameter, dn) having a peelable, contiguous, thermoplastics additional layer on the outside of the pipe (“coated pipe”), see Annex A. In addition it covers: — jointing of pipe lengths by means of butt fusion; — fabricated and injection-moulded fittings made of PE. It is applicable to PE pipes, fittings and assemblies intended to be used at an operating temperature of 20 °C as the reference temperature. NOTE For applications operating at constant temperatures greater than 20 °C and up to 40 °C, see ISO 4427-1:2007, Annex A.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11297-2-2018 PDF

ISO 11297-2-2018 PDF

$60.00 $120.00