ISO 11403-2-2022 PDF

ISO 11403-2-2022 PDF

Plastics-Acquisition and presentation of comparable multipoint data-Part 2: Thermal and processing properties

$60.00 $120.00 -50%
Product Code: ISO 11403-2
Stock In Stock
Edition: 4TH
Published: 07/2022
Number of Pages: 16
File Size: 1 file, 1 Byte

Available Options

Product Description

Plastiques - Acquisition et présentation de données multiples comparables - Partie 2: Propriétés thermiques et caractéristiques relatives à la mise en œuvre

Introduction: This document has been prepared because users of plastics find sometimes that available data cannot be used readily to compare the properties of similar materials, especially when the data have been supplied by different sources. Even when the same standard tests have been used, they often allow the adoption of a wide range of alternative test conditions, and the data obtained are not necessarily comparable. The purpose of this document is to identify specific methods and conditions of test to be used for the acquisition and presentation of data in order that valid comparisons between materials can be made. The ISO 10350 series is concerned with single-point data. Such data represent the most basic method for characterizing materials and are useful for the initial stages of material selection. This document identifies test conditions and procedures for the measurement and presentation of a more substantial quantity of data. Each property here is characterized by multipoint data which demonstrate how that property depends upon important variables such as time, temperature and environmental effects. Additional properties are also considered in this document. These data, therefore, enable more discriminating decisions to be made regarding a material’s suitability for a particular application. Some data are also considered adequate for undertaking predictions of performance in service and of optimum processing conditions for moulding a component, although it should be recognized

Scope: This document specifies test procedures for the acquisition and presentation of multipoint data on the following thermal and processing properties of plastics: — enthalpy/temperature curve; — linear-expansion/temperature curve; — melt shear viscosity.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11403-2-2022 PDF

ISO 11403-2-2022 PDF

$60.00 $120.00