Transportable Gas Cylinders - Periodic Inspection and Testing of Composite Gas Cylinders
Introduction: The principal aim of periodic inspection and testing is that at the completion of the test, the cylinders can be reintroduced into service. It is not possible to identify all considerations for periodic inspection and testing of composite cylinders in this document. In such cases or where there is doubt, questions regarding specific cylinders should be directed to the manufacturer or owner. This document is intended to be used under a variety of national regulatory regimes but has been written so that it is suitable for the application of the UN Model Regulations.[1] This document also gives other requirements concerning preparation, finishing and maintenance of composite cylinders and tubes as well as the safety precautions for the personnel performing this work. These requirements can be mandatory under other regulations. © ISO 2023 – All rights reserved
Scope: This document specifies the requirements for periodic inspection and testing to verify the integrity for further service of hoop-wrapped and fully-wrapped composite transportable gas cylinders and tubes, with aluminium-alloy, steel or non-metallic liners or of linerless construction (Types 2, 3, 4, and 5), intended for compressed, liquefied or dissolved gases under pressure, of water capacity from 0,5 l up to 3 000 l. This document addresses the periodic inspection and testing of composite cylinders and tubes constructed according to ISO 11119-1, ISO 11119-2, ISO 11119-3, ISO 11119-4 or ISO 11515. It can be applied to other composite cylinders and tubes designed to comparable standards when authorized by the competent authority. As far as practicable, this document can also be applied to cylinders of less than 0,5 l water capacity when authorized by the manufacturer. NOTE Unless noted by exception, the use of the word “cylinder” in this document refers to both cylinders and tubes.