ISO 11644-2022 PDF

ISO 11644-2022 PDF

Leather-Test for adhesion of finish

$60.00 $120.00 -50%
Product Code: ISO 11644
Stock In Stock
Edition: 3.
Published: 10/2022
Number of Pages: 20
File Size: 1 file, 1 Byte

Available Options

Product Description

Cuir - Essai d'adhérence du finissage

Introduction: Prior to the first edition of this document in 1993, a similar test method to that specified here, using an expoxy adhesive and metal adherent plates, had been in use in the leather trade for many years, but was never declared an official method by IULTCS or ISO. The adhesive frequently penetrates thin finish films, thus increasing the adhesion value unrealistically, and it is usually not possible to measure wet adhesion as there is insufficient adhesion to the metal when water is present. Finishes with insufficient adhesion to the adhesive also occur quite frequently. In spite of these drawbacks, this old method was used regularly and was referred to in many specifications. The method specified in this document eliminates most of these drawbacks. The adhesives used in this method harden quickly and there is no time for them to penetrate even quite thin finishes unless the finish has open cracks in it. While adhesion to most finishes is sufficient, a few cases still exist in which the adhesion is insufficient and either a different adhesive has to be used or the surface lightly roughened. As the adhesive does not penetrate, it is quite possible to test different layers of a multi-layer finish separately. Such a finish can be tested several times until all the layers have been removed from the leather. It would be advisable for specifications to make allowance for this fact. A strip of hard PVC is used as the adherent plate; this gives good adhesion under wet conditions. Wet a

Scope: This document specifies a method for measuring the adhesion of the finish to leather or the adhesion between two adjacent layers of the finish. The method is valid for all finished flexible leathers with a smooth surface that can be bonded to an adherent plate without the adhesive penetrating into the finish. Preliminary experiments can be necessary to determine whether these conditions are met. This test method applies to finished leathers with a thick finish-coat. The method specified in this document does not apply to unpigmented articles or articles without a continuous coating layer, such as: — nubuk; — aniline; — pull-up; — suede; — perforated leather.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11644-2022 PDF

ISO 11644-2022 PDF

$60.00 $120.00