Tractors and machinery for agriculture and forestry — Serial control and communications data network — Part 1: General standard for mobile data communication
Introduction: ISO 11783 specifies a communications system for agricultural equipment based on the ISO 11898-2 protocol. SAE J1939 documents1), on which parts of ISO 11783 are based, were developed jointly for use in truck and bus applications and for construction and agriculture applications. Joint documents were completed to allow electronic units that meet the truck and bus SAE J1939 specifications to be used by agricultural and forestry equipment with minimal changes. General information on ISO 11783 is to be found in this part of ISO 11783. The purpose of ISO 11783 is to provide an open, interconnected system for on-board electronic systems. It is intended to enable electronic control units (ECUs) to communicate with each other, providing a standardized system. 1) Society of Automotive Engineers, Warrendale, PA, USA. © ISO 2017 – All rights reserved
Scope: ISO 11783 as a whole specifies a serial data network for control and communications on forestry or agricultural tractors and mounted, semi-mounted, towed or self-propelled implements. Its purpose is to standardize the method and format of transfer of data between sensors, actuators, control elements, and information-storage and -display units, whether mounted on, or part of, the tractor or implement. It is intended to provide open system interconnect (OSI) for electronic systems used by agricultural and forestry equipment. This part of ISO 11783 gives a general overview of ISO 11783. For ISO 11783 application developers, the content of this electronic database provides the current listing of the ISO 11783-1 address assignments, identity assignments, and parameter definitions which have been assigned and which are officially registered by SAE J1939. This information is found in the online database on the ISOBUS website (http://www.isobus.net/). NOTE The secretariat of the maintenance agency (MA) is provided by VDMA (German Engineering Federation) on behalf of DIN.