ISO 11855-6-2018 PDF

ISO 11855-6-2018 PDF

Building environment design - Design, dimensioning, installation and control of embedded radiant heating and cooling systems - Part 6: Control

$13.00 $26.00 -50%
Product Code: ISO 11855-6
Stock In Stock
Edition: 2.
Published: 09/2018
Number of Pages: 20
File Size: 1 file, 1 Byte

Available Options

Product Description

Building environment design - Design, dimensioning, installation and control of embedded radiant heating and cooling systems - Part 6: Control

Introduction: The radiant heating and cooling system consists of heat emitting/absorbing, heat supply, distribution, and control systems. The ISO 11855 series deals with the embedded surface heating and cooling system that directly controls heat exchange within the space. It does not include the system equipment itself, such as heat source, distribution system and controller. The ISO 11855 series addresses an embedded system that is integrated with the building structure. Therefore, the panel system with open air gap, which is not integrated with the building structure, is not covered by this series. The ISO 11855 series is intended to be applied to systems using not only water but also other fluids or electricity as a heating or cooling medium. The objective of the ISO 11855 series is to provide criteria to effectively design embedded systems. To do this, it presents comfort criteria for the space served by embedded systems, heat output calculation, dimensioning, dynamic analysis, installation, operation, and control method of embedded systems. The ISO 11855 series consists of the following: — Part 1 specifies the comfort criteria which should be considered in designing embedded radiant heating and cooling systems, since the main objective of the radiant heating and cooling system is to satisfy thermal comfort of the occupants. — Part 2 provides steady-state calculation methods for determination of the heating and cooling capacity. — Part 3 specifies design and dimensioning methods of rad

Scope: This document establishes guidelines for the control of embedded radiant heating and cooling systems. It specifies uniform requirements for the design and construction of heating and cooling floors, ceiling and wall structures to ensure that the heating/cooling systems are suited to the particular application. The requirements specified in this document are applicable only to the components of the heating/ cooling systems and the elements which are part of the heating/cooling surface and which are installed due to the heating/cooling systems. This document is applicable to water-based embedded surface heating and cooling systems in residential, commercial and industrial buildings. The methods apply to systems integrated into the wall, floor or ceiling construction without any open air gaps. It is not applicable to panel systems with an open air gap which is not integrated with the building structure. This document also applies, as appropriate, to the use of fluids other than water as a heating or cooling medium. This document is not applicable for testing of systems. The methods do not apply to heated or chilled ceiling panels or beams.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 11855-6-2018 PDF

ISO 11855-6-2018 PDF

$13.00 $26.00