Connections for hydraulic fluid power and general use — Hose fittings — Part 3: Hose fittings with ISO 6162-1 or ISO 6162-2 flange ends
Introduction: In hydraulic fluid power systems, power is transmitted and controlled through a liquid under pressure within an enclosed circuit. In general applications, the fluid can be conveyed under pressure. Components are connected through their ports by stud ends on fluid conductor connectors to tubes/ pipes or to hose fittings and hoses. ISO 12151-3:2021(E) © ISO 2021 – All rights reserved
Scope: This document specifies the general and dimensional requirements for the design and performance of flange hose fittings, made of carbon steel, for nominal hose inside diameters of 12,5 mm to 76 mm inclusive, in accordance with ISO 4397, for use with ports and clamps in accordance with ISO 6162-1 and ISO 6162-2. Note 1 Materials other than carbon steel can be supplied as agreed between the manufacturer and user. Note 2 For hose fittings used in hydraulic and pneumatic braking systems on road vehicles (as defined in the scope of ISO/TC 22/SC 2, Road vehicles), see ISO 4038, ISO 4039-1 and ISO 4039-2. These hose fittings (see Figure 1 for a typical example) are for use in hydraulic fluid power systems with a hose that meets the requirements of the respective hose standards and in general applications with suitable hoses. Key hose fitting port, flanged head and clamps, as per ISO 6162-1 or ISO 6162-2 O-ring seal Figure 1 — Typical example of hose fitting connection with ISO 6162-1 or ISO 6162-2 flange end ISO 12151-3:2021(E) © ISO 2021 – All rights reserved 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 1302, Geometrical Product Specifications (GPS) — Indication of surface texture in technical product documentation ISO 4397, Fluid power connectors and associated components — Nominal outside diameters of tubes and nominal hose sizes ISO 5598, Fluid power systems and components — Vocabulary ISO 6162-1, Hydraulic fluid power — Flange connections with split or one-piece flange clamps and metric or inch screws — Part 1: Flange connectors, ports and mounting surfaces for use at pressures of 3,5 MPa (35 bar) to 35 MPa (350 bar), DN 13 to DN 127 ISO 6162-2, Hydraulic fluid power — Flange connections with split or one-piece flange clamps and metric or inch screws — Part 2: Flange connectors, ports and mounting surfaces for use at a pressure of 42 MPa (420 bar), DN 13 to DN 76 ISO 9227, Corrosion t