Small craft — Hull construction and scantlings — Part 10: Rig loads and rig attachment in sailing craft
Introduction: The reason underlying the preparation of the ISO 12215 series is that scantlings rules and recommended practices for small craft differ considerably, thus limiting the general worldwide acceptability of craft. This document has been set towards the minimal requirements of the current practice. The dimensioning according to this document is regarded as reflecting current practice, provided the craft is correctly handled in the sense of good seamanship and equipped and operated at a speed appropriate to the prevailing sea state. This document is not a design standard and designers/builders are strongly cautioned from attempting to design craft such that nearly all structural components only just comply. The connection between the rig attachment and the structure is required to be stronger than the rig attachment itself. It is therefore considered that unforeseen overload will not entail its detachment from the structure, and that the watertight integrity will be maintained. vi © ISO 2020 – All rights reserved
Scope: This document specifies methods for the determination of: — the design loads and design stresses on rig elements; and — the loads and scantlings of rig attachments and mast steps/pillars; on monohull and multihulls sailing craft. It also gives, in Annexes, "established practices" for the assessment of mast steps/pillars or chainplates NOTE 1 Other engineering methods can be used provided the design loads and design stresses are used. This document is applicable to craft with a hull length LH up to 24 m but it can also be applied to craft up to 24 m load line length. NOTE 2 The load line length is defined in the OMI "International Load Lines Convention 1966/2005", it is smaller than LH. This length also sets up, at 24 m, the lower limit of several IMO conventions. Scantlings derived from this document are primarily intended to apply to recreational craft, including charter vessels. This document is not applicable to racing craft designed only for professional racing. This document only considers the loads exerted when sailing. Any loads that may result from other situations are not considered in this document. Throughout this document, and unless otherwise specified, dimensions are in (m), areas in (m2), masses in (kg), forces in (N), moments in (N m), stresses and elastic modulus in N/mm2 (1 N / mm2 = 1 Mpa). Unless otherwise stated, the craft is assessed in fully loaded ready for use condition.