Graphic technology — Safety requirements for graphic technology equipment and systems — Part 4: Converting equipment and systems
Introduction: This document is a type-C standard as stated in ISO 12100:2010. This document is of relevance, in particular, for the following stakeholder groups representing the market players with regard to machinery safety: — machine manufacturers (small, medium and large enterprises); — health and safety bodies (regulators, accident prevention organizations, market surveillance, etc.). Others can be affected by the level of machinery safety achieved with the means of the document by the above-mentioned stakeholder groups: — machine users/employers (small, medium and large enterprises); — machine users/employees (e. g. trade unions, organizations for people with special needs); — service providers, e. g. for maintenance (small, medium and large enterprises); — consumers (in the case of machinery intended for use by consumers). The above-mentioned stakeholder groups have been given the possibility to participate at the drafting process of this document. The machinery concerned and the extent to which hazards, hazardous situations or hazardous events are covered are indicated in the Scope of this document. The purpose of this document is to reduce the risk of injury to operating personnel working on converting equipment. During the development of this document, existing relevant standards of other countries were taken into consideration. In cases where it was known that there is a national requirement that differs from this document, that has been noted. This document was developed to harm
Scope: This document deals with all significant hazards, hazardous situations or hazardous events relevant to converting equipment and systems used in the corrugated board, package printing, converting and graphic technology industries (see Clause 5), when it is used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer. This document is applicable to converting equipment not covered by other parts of ISO 12643. This document is not applicable to the machinery or machinery components manufactured before the date of its publication.