Graphic technology — Safety requirements for graphic technology equipment and systems — Part 5: Manually-fed stand-alone platen presses
Introduction: This document is a type-C standard as stated in ISO 12100:2010. This document is of relevance, in particular, for the following stakeholder groups representing the market players with regard to machinery safety: — machine manufacturers (small, medium and large enterprises); — health and safety bodies (regulators, accident prevention organisations, market surveillance, etc.) Others can be affected by the level of machinery safety achieved with the means of the document by the above-mentioned stakeholder groups: — machine users/employers (small, medium and large enterprises); — machine users/employees (e.g. trade unions, organizations for people with special needs); — service providers, e. g. for maintenance (small, medium and large enterprises); — consumers (in case of machinery intended for use by consumers). The above-mentioned stakeholder groups have been given the possibility to participate at the drafting process of this document. The machinery concerned and the extent to which hazards, hazardous situations or hazardous events are covered are indicated in the Scope of this document. During the development of this document, existing relevant standards of other countries were taken into consideration. In cases where it was known that there is a national requirement that differs from this document, that has been noted. When requirements of this type-C standard are different from those which are stated in type-A or type-B standards, the requirements of this type-C standard ta
Scope: This document provides safety requirements specific to stand-alone platen presses. This document provides additional safety requirements for the design and construction of manually- fed stand-alone platen presses, for single stroke mode, dwell mode, and continuous operation mode for cutting and creasing, embossing, foil stamping and/or printing of paper, board and other materials processed in a similar manner. This document does not apply to presses designed to handle metal material other than foil.