Measurement of fluid flow in closed conduits - Flowrate measurement by means of vortex shedding flowmeters inserted in circular cross-section conduits running full
Introduction: This document is one of the series of International Standards and Technical Reports covering a variety of devices that measure the flow of fluids in closed conduits. The term “vortex shedding flowmeter”, commonly referred to as a “vortex meter”, covers a large family of devices with varying proprietary designs. These devices have in common the shedding of vortices from an obstruction (called a bluff body) which has been deliberately placed in the flow path in the meter. The natural laws of physics relate the shedding frequency of the vortices (f) to the fluid velocity and hence the volumetric flowrate (qV) of the fluid in the conduit. The vortices can be counted over a given period of time to obtain total flow. The vortex shedding phenomenon has become an accepted basis for fluid flow measurement. Meters are available for measuring the flow of fluids from cryogenic liquids to steam and high pressure gases. Many vortex shedding flowmeter designs are proprietary and, therefore, their design details cannot be covered in this document. Insufficient data have been collected and analysed to be able to state, in this document, an expected uncertainty band for this type of vortex-shedding flowmeter. vi © ISO 2017 – All rights reserved
Scope: This document a) describes the use of vortex shedding flow meters for liquids, gases, and steam, including a glossary and a set of engineering equations used for specifying performance, b) provides technical information to assist the user in selecting, specifying and applying vortex shedding flowmeters, including influence effects, c) describes typical construction and provides recommendations for inspection, certification, and material traceability, d) describes availability of diagnostics associated with vortex shedding flowmeters, e) provides calibration guidance, f) does not apply to insertion type vortex shedding flowmeters, g) applies only to closed conduits running full, h) applies only to fluid flow that is steady or varies only slowly with time, and i) applies to fluids considered to be single-phase.