Determination of particle size distribution by gravitational liquid sedimentation methods — Part 1: General principles, requirements and guidance
Introduction: Gravitational sedimentation has been an established principle of particle size analysis for several decades. It is employed in various academic and industrial fields of application. Numerous national and international standards address gravitational sedimentation techniques and analytical methods. Although manifold new particle sizing techniques have emerged during the last two decades, sedimentation techniques have been recently rediscovered. This is due to substantial technical advancements and the fact that they are based on a first-principle measurement of the particles’ directed motion (migration) under gravity. The measurands of gravitational sedimentation techniques are the distributions of sedimentation velocity and corresponding particle size. They are derived from observations of phase separation – either by monitoring the deposition of particles or the depletion of dispersion. The physical principles employed to determine the quantity of particles differ widely, whereas sedimentation velocity is in each case computed from the vertically migrated distance and measurement time. This computation does not demand essential preconditions and theoretical assumptions. Yet, the transformation of velocity into particle size relies on the applicability of Stokes’ law. As fractionating technique, sedimentation analysis can distinguish between particle fractions of close sedimentation velocity. Accordingly, particle size distributions can be very finely resolved, which is an ad
Scope: This document specifies the principles of particle size analysis by gravitational sedimentation, the principal types of measurement techniques as well as the general rules for conducting measurements, method validation, determination of the uncertainty budget and representation of results. This document covers neither particle migration by centrifugal, electric or magnetic forces nor sedimentation at high particle concentrations (e.g. zone sedimentation). Moreover, this document does not deal with the determination of properties other than sedimentation velocity and particle size (i.e. neither particle concentration, particle shape, particle density, zeta-potential nor apparent viscosity). NOTE This document can involve hazardous materials, operations and equipment. This document does not purport to address all the safety problems associated with its use. Explosion proof analysers are required when examining volatile liquids with a low flash point.