Determination of particle size distribution by centrifugal liquid sedimentation methods — Part 1: General principles, requirements and guidance
Introduction: Particle size analysis by centrifugal liquid sedimentation (CLS) methods has been performed for several decades, and there are numerous national and international standards employed in various academic and industrial applications. Along with the development of manifold new measurement techniques during the last two decades, sedimentation methods are currently enjoying a renaissance due to technical progress (e.g. multiwavelength features) and the fact that most sedimentation techniques are based on the first-principle measurement of the directed motion (migration) of particles in gravitational or centrifugal fields. The rate of this motion is the particle sedimentation velocity, its acceleration-specific value is called "sedimentation coefficient". Both are individual particle properties, which are related to the particles’ external dimensions, and can be considered as primary measurands of liquid sedimentation methods. Analytical centrifuges determine distributions of these primary measurands from the variation of concentration-dependent signals over time and/or along the radial coordinate of the centrifugal field. This step does not require any pre-knowledge of the dispersed or liquid phase. Further, data processing allows for particle size distributions to be derived from sedimentation velocity and sedimentation coefficient. For this purpose, spherical particles and the applicability of Stokes’ law are assumed; the equivalent particle diameter is called the Stokes diameter
Scope: This document specifies the principles of particle size analysis by centrifugal liquid sedimentation (CLS). It also: — defines the relevant terms; — describes the various measurement techniques; — gives guidance for sample preparation, conducting measurements as well as data analysis; — establishes rules for method validation, determination of the uncertainty budget as well as representation of results. An important part of this document deals with the derivation of particle size distributions from CLS data, including discussions on: — the impact of Brownian motion; — the parallel determination of particle concentrations; — the working range with respect to size and concentration; —the handling of non-spherical and porous particles. This document applies to samples composed of dispersions of low particle concentration, so that the particles’ motion can be considered as that of fully isolated particles. This document does not cover particle migration by gravity, electric or magnetic forces. It also does not cover deriving particle properties other than size, sedimentation velocity and sedimentation coefficient. NOTE This document can involve hazardous materials, operations and equipment. It does not purport to address all the safety problems associated with its use. Regulations regarding explosion-proof analysers can apply when examining volatile liquids with a low flash point. It is the responsibility of the user of this document to establish appropriate safety and health practices and to determine the applicability of the regulatory limitations prior to its use.