Estimation of the lethal toxic potency of fire effluents
Introduction: The pyrolysis or combustion of every combustible material produces a fire effluent atmosphere, which, in sufficiently high concentration, is toxic. It is, therefore, desirable to establish a standard test method for the estimation of the toxic potency of such fire effluents. It is further desirable, in view of worldwide resistance to the exposure of animals in standard tests, that this method should not make mandatory the use of such animals in its procedures. The mandatory portion of this standard test does not, therefore, specify the use of animal exposures. It only refers to animal exposure data already reported in the literature, with calculations being employed to express test results as they would have been obtained had animals actually been employed. For those cases in which confirmation of test results using animal exposures can be justifiably permitted, an optional procedure to do so is presented in Annex A. The two parameters calculated using this standard are the FED (Fractional Effective Dose) and the LC50. When either of these is used in performing a hazard analysis, certain information must accompany the term to avoid confusion. In the case of the FED, that is the toxicological effect on which the FED is based and the animal species for which the FED has been determined. In the case of the LC50, that information is the length of the exposure and the animal species for which the LC50 has been determined. © ISO 2015 – All rights reserved
Scope: This International Standard provides a means for estimating the lethal toxic potency of the fire effluent produced from a material while exposed to the specific combustion conditions of a physical fire model. The lethal toxic potency values are specifically related to the fire model selected, the exposure scenario and the material evaluated. Lethal toxic potency values associated with 30-min exposures of rats are predicted using calculations which employ combustion atmosphere analytical data for carbon monoxide (CO), carbon dioxide (CO2), oxygen (O2) (vitiation) and, if present, hydrogen cyanide (HCN), hydrogen chloride (HCl), hydrogen bromide (HBr), hydrogen fluoride (HF), sulfur dioxide (SO2), nitrogen dioxide (NO2), acrolein and formaldehyde. The chemical composition of the test specimen may suggest additional combustion products to be quantified and included. If the fire effluent toxic potency cannot be attributed to the toxicants analysed (Annex A), this is an indication that other toxicants or factors must be considered. This International Standard is applicable to the estimation of the lethal toxic potency of fire effluent atmospheres produced from materials, products or assemblies under controlled laboratory conditions and should not be used in isolation to describe or appraise the toxic hazard or risk of materials, products or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire hazard assessment that takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use; see ISO 19706. The intended use of fire safety-engineering calculations is for life-safety prediction for people and is most frequently for time intervals somewhat shorter than 30 min. This extrapolation across species and exposure intervals is outside the scope of this International Standard. This International Standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this International Standard to establish appropriate safety and health practices.