ISO 13357-2-2025 PDF

ISO 13357-2-2025 PDF

Petroleum products-Determination of the filterability of lubricating oils-Part 2: Procedure for dry oils

$60.00 $120.00 -50%
Product Code: ISO 13357-2
Stock In Stock
Edition: 4.
Published: 04/2025
Number of Pages: 22
File Size: 1 file, 1 Byte

Available Options

Product Description

Produits pétroliers — Détermination de la filtrabilité des huiles lubrifiantes — Partie 2: Méthode pour les huiles non polluées par de l'eau

Introduction: To minimize wear on the components of an oil-lubricated system, it is important to reduce the concentrations of circulating hard contaminant particles. This is particularly important for hydraulic power systems, for systems whose performance and reliability rely on the maintenance of small clearances and orifices, or for systems that include rolling element bearings as components. These contaminants are removed by the use of filters. The ability of an oil to pass through fine filters, without plugging them, is called its filterability. This document describes a laboratory test procedure for assessing the filterability of mineral oils in a dry state. Filterability so determined is not a physical characteristic of the oil, but represents an estimation of its behaviour in service. This document describes two measurements, referred to as “stages”. The stage I determination is based on a comparison of the mean flow rate of a fluid through a test membrane with its initial flow rate. Oils having good stage I filterability, but a poor stage II performance (see below), are unlikely to have performance problems in use, unless extremely fine system filters are utilized. The stage II determination is based upon the ratio between the initial flow rate of the fluid through the test membrane and the rate at the end of the test. This part of the procedure is a more severe test and is more sensitive to the presence of gels and fine silts in the oil. Silts and gels can be present in an oil whe

Scope: This document specifies a procedure for the evaluation of the filterability of dry lubricating oils. The procedure only applies to mineral-based oils, since fluids manufactured from other materials (e.g. fire- resistant fluids) can be incompatible with the specified test membranes. This document is applicable to oils of viscosity up to ISO viscosity grade (VG) 100, as defined in ISO 3448. These oils are widely used as hydraulic fluids, and within the range described, the variation in filterability due to viscosity is included within the precision range of this document. The procedure is not suitable for some hydraulic oils on which specific properties are conferred by the use of insoluble or partially soluble additives, or by particularly large molecular species. These additives include some viscosity index modifiers and some friction modifying additives. This document can also be applied to oils of ISO viscosity grades (VG) 150, 220 and 320, as defined in ISO 3448, using the specified 3,0 µm rated membranes. These oils are widely used as heavy-duty lubricants in equipment such as paper making machines and rolling mills. Within the range described, the filterability as defined is not dependent on the viscosity of the oil.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 13357-2-2025 PDF

ISO 13357-2-2025 PDF

$60.00 $120.00