ISO 13400-3-2016 PDF

ISO 13400-3-2016 PDF

Road vehicles - Diagnostic communication over Internet Protocol (DoIP) - Part 3: Wired vehicle interface based on IEEE 802.3

$71.50 $143.00 -50%
Product Code: ISO 13400-3
Stock In Stock
Edition: 2ND
Published: 11/15/2016
Number of Pages: 22
File Size: 1 file, 1 Byte

Available Options

Product Description

Road vehicles - Diagnostic communication over Internet Protocol (DoIP) - Part 3: Wired vehicle interface based on IEEE 802.3

Introduction: Vehicle diagnostic communication has been developed starting with the introduction of the first legislated emissions-related diagnostics and has evolved over the years, now covering various use cases ranging from emission-related diagnostics to vehicle-manufacturer-specific applications like calibration or electronic component software updates. With the introduction of new in-vehicle network communication technologies, the interface between the vehicle’s electronic control units and the test equipment has been adapted several times to address the specific characteristics of each new network communication technology requiring optimized data link layer definitions and transport protocol developments in order to make the new in-vehicle networks usable for diagnostic communication. With increasing memory size of electronic control units, the demand to update this increasing amount of software and an increasing number of functions provided by these control units, technology of the connecting network and buses has been driven to a level of complexity and speed similar to computer networks. New applications (x-by-wire, infotainment) require high band-width and real-time networks (like FlexRay, MOST), which cannot be adapted to provide the direct interface to a vehicle. This requires gateways to route and convert messages between the in-vehicle networks and the vehicle interface to test equipment. The intent of ISO 13400 (all parts) is to describe a standardized vehicle interface whi

Scope: This document specifies the vehicle communication interface and test equipment requirements for a physical and data link layer based on IEEE 802.3 100BASE-TX. This interface serves as the physical basis for IP-based communication between the vehicle and test equipment. This document specifies the following aspects: — requirements for signal and wiring schematics in order to ensure physical layer compatibility of the vehicle interface and Ethernet networks and test equipment communication interfaces; — discovery/identification of the in-vehicle diagnostic Ethernet interface; — activation and deactivation of the in-vehicle diagnostic Ethernet interface; — mechanical and electrical diagnostic connector requirements; — this edition has been modified to include the identification of two Ethernet pin assignments.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 13400-3-2016 PDF

ISO 13400-3-2016 PDF

$71.50 $143.00