ISO 13472-2-2025 PDF

ISO 13472-2-2025 PDF

Acoustics-Measurement of sound absorption properties of road surfaces in situ-Part 2: Spot method for reflective surfaces

$96.50 $193.00 -50%
Product Code: ISO 13472-2
Stock In Stock
Edition: 2.
Published: 05/2025
Number of Pages: 32
File Size: 1 file, 2 Bytes

Available Options

Product Description

Acoustics — Measurement of sound absorption properties of road surfaces in situ — Part 2: Spot method for reflective surfaces

Introduction: This method provides a means to evaluate the sound absorption characteristics of a road surface without damaging the surface. The field of application is limited to low absorption surfaces such as those in accordance with ISO 10844[2] and similar surfaces. Due to air leakage the method is not reliable if the measured sound absorption coefficient exceeds 0,15. Surfaces with a sound absorption coefficient of 0,10 or below are considered reflective. The method in this document is based on propagation of the test signal from the source to the road surface and back to the receiver through an impedance tube with a diameter of 80 mm to 100 mm. The tube covers an area of approximately 0,005 m2 to 0,008 m2 and a frequency range, in one-third octave bands, from 250 Hz to 1 600 Hz for a 100 mm diameter, or from 250 Hz to 2 000 Hz, for an 80 mm diameter tube. It uses the test procedure and signal processing described in ISO 10534-2, but because of the defined frequency range of application, the dimensions of the system are not freely adjustable. The essential part in the ISO 10534-2 procedure is the determination of the transfer function between two microphones at different distances from the sample at the end of the tube. In this case of a reflecting sample at specific frequencies destructive interferences (nodes) will occur at the microphone positions jeopardizing the correct determination of the transfer function between the microphone pair. Therefore in this document the ISO 10534-2

Scope: This document specifies a test method for measuring in situ the sound absorption coefficient of road surfaces for the one-third octave band frequencies ranging from 250 Hz to 1 600 Hz under normal incidence conditions. If necessary for practical applications the diameter of the tube can be reduced to 80 mm. This will increase the upper boundary of the frequency range to 2 000 Hz one-third octave band (see 5.4) but reduces the area under test. The test method is intended for the following applications: — determination of the sound absorption coefficient (and, if of interest, also the complex acoustical impedance) of semi-dense to dense road surfaces; — determination of the sound absorption properties of test tracks according to ISO 10844[2] or other similar standards and test surfaces defined in national and international type approval regulations for road vehicles and their tyres; — verification of the compliance of the sound absorption coefficient of a road surface with design- specifications or other requirements.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 13472-2-2025 PDF

ISO 13472-2-2025 PDF

$96.50 $193.00