Heating and cooling systems in buildings - Method for calculation of the system performance and system design for heat pump systems - Part 2: Energy calculation
Introduction: This International Standard is a part of a series of standards on the methods for calculation of heating system energy requirements and heating and cooling system efficiencies. — ISO 13612-1 deals with design and sizing of heat pump systems. — ISO 13612-2 presents the energy calculation method. The energy performance can be assessed by determining either the heat generation subsystem efficiencies or the heat generation subsystem losses due to the system configuration. This part of ISO 13612 presents methods for calculation of the additional energy requirements of a heat generation subsystem in order to meet the distribution subsystem demand. The calculation is based on the performance characteristics of the products given in product standards and on other characteristics required to evaluate the performance of the products as included in the system. Product data, e.g. heating capacity or COP of the heat pump, is determined according to products standards. This method can be used for the following applications: — judging compliance with regulations expressed in terms of energy targets; — optimization of the energy performance of a planned heat generation subsystem, by applying the method to several possible options; — assessing the effect of possible energy conservation measures on an existing heating/cooling generation subsystem, by calculating the energy use with and without the energy conservation measure. Only the calculation method is normative. The user shall refer to ot
Scope: This International Standard is applicable to heat pumps for space heating and cooling, heat pump water heaters (HPWH), and heat pumps with combined space heating and/or cooling and domestic hot water production, in alternate or simultaneous operation, where the same heat pump is used for space heating and domestic hot water heating. This part of ISO 13612 provides a calculation method under steady conditions that corresponds to one calculation step. The results of this calculation are incorporated in larger building models and take into account the influence of the external conditions and building control that influence the energy requirements for heating and cooling supplied by the heat pump system. This part of ISO 13612 specifies the required inputs, calculation methods, and required outputs for output thermal power generation for space heating and cooling and domestic hot water production of the following heat pump systems, including control: — electrically driven vapour compression cycle (VCC) heat pumps; — combustion engine-driven vapour compression cycle heat pumps; — thermally driven vapour absorption cycle (VAC) heat pumps, using combinations of heat source and heat distribution listed in Table 1. Table 1 — Heating/cooling sources and energy distribution Source Distribution Outdoor air Air Exhaust-air Water Indirect ground source with brine distribution Direct condensation/evaporation of the refrigerant in the appliance (VRF) Indirect ground source with water distribution Direct ground source [Direct expansion (DX)] Surface water Ground water