ISO 13628-5-2009 PDF

ISO 13628-5-2009 PDF

Petroleum and natural gas industries-Design and operation of subsea production systems-Part 5: Subsea umbilicals

$60.00 $120.00 -50%
Product Code: ISO 13628-5
Stock In Stock
Edition: 2ND
Published: 12/15/2009
Number of Pages: 178
File Size: 1 file, 1 Byte

Available Options

Product Description

Petroleum and Natural Gas Industries - Design and Operation of Subsea Production Systems - Part 5: Subsea Umbilicals

Introduction: This part of ISO 13628 is based on the first edition of ISO 13628-5, which was based on API Spec 17E, second edition and API RP 17I, first edition. The first edition of ISO 13628-5 was adopted by API as API Spec 17E, third edition. It is intended that API Spec 17E, fourth edition, will be identical to this International Standard. It is important that users of this part of ISO 13628 be aware that further or differing requirements can be needed for individual applications. This part of ISO 13628 is not intended to inhibit a vendor from offering, or the purchaser from accepting, alternative equipment engineering solutions for the individual application. This can be particularly applicable if there is innovative or developing technology. If an alternative is offered, it is the responsibility of the vendor to identify any variations from this part of ISO 13628 and provide details. In this part of ISO 13628, where practical, US Customary (USC) and other units are included in parentheses for information.

Scope: This part of ISO 13628 specifies requirements and gives recommendations for the design, material selection, manufacture, design verification, testing, installation and operation of umbilicals and associated ancillary equipment for the petroleum and natural gas industries. Ancillary equipment does not include topside hardware. Topside hardware refers to any hardware that is not permanently attached to the umbilical, above the topside hang-off termination. This part of ISO 13628 applies to umbilicals containing components, such as electrical cables, optical fibres, thermoplastic hoses and metallic tubes, either alone or in combination. This part of ISO 13628 applies to umbilicals for static or dynamic service, with surface-surface, surface- subsea and subsea-subsea routings. This part of ISO 13628 does not apply to the associated component connectors, unless they affect the performance of the umbilical or that of its ancillary equipment. This part of ISO 13628 applies only to tubes with the following dimensions: wall thickness, t < 6 mm, internal diameter, ID < 50,8 mm (2 in). Tubular products greater than these dimensions can be regarded as pipe/linepipe and it is expected that they be designed and manufactured according to a recognised pipeline/linepipe standard. This part of ISO 13628 does not apply to a tube or hose rated lower than 7 MPa (1 015 psi). This part of ISO 13628 does not apply to electric cable voltage ratings above standard rated voltages U U = 3,6/6(7,2) kV rms, where U0, U and Um are as defined in IEC 60502-1 and IEC 60502-2.

Contents:

  • Foreword
  • Introduction
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 13628-5-2009 PDF

ISO 13628-5-2009 PDF

$60.00 $120.00