ISO 13646-2025 PDF

ISO 13646-2025 PDF

Water quality-Determination of selected estrogens in whole water samples-Method using solid phase extraction (SPE) followed by liquid chromatography (LC) or gas chromatography (GC) coupled to mass spectrometry (MS) detection

$145.50 $291.00 -50%
Product Code: ISO 13646
Stock In Stock
Edition: 1.
Published: 10/2025
Number of Pages: 70
File Size: 1 file, 3 Bytes

Available Options

Product Description

Water quality — Determination of selected estrogens in whole water samples — Method using solid phase extraction (SPE) followed by liquid chromatography (LC) or gas chromatography (GC) coupled to mass spectrometry (MS) detection

Introduction: Natural and synthetic estrogens are widely used worldwide, e.g. for contraception. Through application or improper disposal, these estrogens can enter the water cycle unchanged or transformed. They can therefore be detected in surface and groundwater, as well as in treated wastewater. It is known that estrogens can end up in surface waters via wastewater, and due to their physicochemical properties, they can partition in the different compartments [water and suspended particulate matter (SPM)] of water systems. They are of rising concern, due to their high estrogenic activity even at the measured ultra-trace levels (far below ng/l). Besides feminised fish and other endocrine disruptive effects in water ecosystems, they can also be a factor in biodiversity loss.[16] Therefore, appropriate measurement methods are required to monitor estrogen levels below their ecotoxicological level [e.g. predicted no effect concentration (PNEC) or environmental quality standard (EQS)] and accordingly demonstrate if a water body is at risk. This document specifies validated methods for analysing water samples in monitoring programs aiming at qualifying the quality of the water environment with respects to the selected estrogens. © ISO 2025 – All rights reserved

Scope: This document specifies methods for the determination of five selected estrogens in whole water samples listed in Table 1 (see Clause 4). The methods are based on solid-phase extraction (SPE; disk or cartridge) followed by liquid or gas chromatography-mass spectrometry detection (tandem mass spectrometry or high resolution mass spectrometry). Depending on the sample preparation chosen, the sample preparation can be applicable to the analysis of selected estrogens in drinking water, groundwater and surface water containing suspended particulate matter (SPM) up to 500 mg/l, dissolved organic carbon (DOC) content up to 14 mg/l (whole water samples). The lower application range defined as verified limit of quantification can vary depending on the methods, the sensitivity of the equipment used and the matrix of the sample. The range is 0,006 ng/l to 1 ng/l for 17alpha-ethinylestradiol (EE2) and 0,038 ng/l to 1 ng/l for the other estrogens in drinking water, ground water and surface water. The upper limit of the working range is approximately tens of nanograms per litre. For application that targets the measurements of very low level concentrations (between the lowest LOQ and 0,1 ng/l), every single step of the procedure becomes critical. The methods can be used to determine further estrogens or hormones in other types of water, for example treated wastewater, if accuracy has been tested and verified for each case as well as storage conditions of both samples and reference solutions have been validated.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 13646-2025 PDF

ISO 13646-2025 PDF

$145.50 $291.00