Earth-moving and building construction machinery - Electromagnetic compatibility (EMC) of machines with internal electrical power supply - Part 2: Additional EMC requirements for functional safety
Introduction: This document is a type-C standard as stated in ISO 12100:2010. This document is of relevance, in particular, for the following stakeholder groups representing the market players with regard to machinery safety: — machine manufacturers (small, medium and large enterprises); — health and safety bodies (regulators, accident prevention organisations, market surveillance etc.) Others can be affected by the level of machinery safety achieved with the means of the document by the above-mentioned stakeholder groups: — machine users/employers (small, medium and large enterprises); — machine users/employees (e.g. trade unions, organizations for people with special needs); — service providers, e.g. for maintenance (small, medium and large enterprises); — consumers (in case of machinery intended for use by consumers). The above-mentioned stakeholder groups have been given the possibility to participate at the drafting process of this document. The machinery concerned and the extent to which hazards, hazardous situations or hazardous events are covered are indicated in the Scope of this document. When requirements of this type-C standard are different from those which are stated in type-A or type-B standards, the requirements of this type-C standard take precedence over the requirements of the other standards for machines that have been designed and built according to the requirements of this type-C standard. With the increasing use of electronic devices in areas where earth-moving and c
Scope: This document provides test methods and acceptance criteria for the evaluation of the electromagnetic compatibility (EMC) of earth-moving machinery, as defined in ISO 6165:2012, and of the following building construction machinery as classified in ISO/TR 12603:2010: — drilling and foundation equipment; — equipment used for the preparation, conveyance and compaction of concrete, mortar and processing reinforcement; — road construction and maintenance machinery and equipment. It deals with EMC requirements related to the functional safety of the machinery, its electrical/ electronic subassemblies (ESA) and of separate ESA. This document is relevant only to the safety-related parts of control systems (SRP/CS) as defined in ISO 13849-1:2015 using electrical/electronic components which meet design requirements equal to or greater than safety‑related performance level PL b as defined in ISO 13849-1:2015. It also deals with electrical and electronic components or separate ESA intended to be fitted on machinery under the restriction of PL b. The following electromagnetic disturbance phenomena are evaluated: — radiated electromagnetic fields from off-board sources with various field strengths and frequencies; — radiated electromagnetic fields from on-board sources (antenna inside/outside) with various field strengths and frequencies; — electrostatic discharge; — conducted and coupled electrical transients. The machinery can have DC or AC or a combination of both as the internal electrical power supply system. This document is not applicable to machines that are designed to be supplied by an external mains network or to phenomena caused by military applications. NOTE Grid-connected machines are covered by IEC 61000.