ISO 14253-1-2017 PDF

ISO 14253-1-2017 PDF

Geometrical product specifications (GPS) - Inspection by measurement of workpieces and measuring equipment - Part 1: Decision rules for verifying conformity or nonconformity with specifications

$96.50 $193.00 -50%
Product Code: ISO 14253-1
Stock In Stock
Edition: 3RD
Published: 10/2017
Number of Pages: 30
File Size: 1 file, 1 Byte

Available Options

Product Description

Geometrical product specifications (GPS) - Inspection by measurement of workpieces and measuring equipment - Part 1: Decision rules for verifying conformity or nonconformity with specifications

Introduction: This document is a geometrical product specifications (GPS) standard and is to be regarded as a general GPS standard (see ISO 14638). It influences the chain link D of all chains of general GPS standards. The ISO/GPS Matrix model given in ISO 14638 gives an overview of the ISO/GPS system of which this document is a part. The fundamental rules of ISO/GPS given in ISO 8015 apply to this document and the default decision rules given in this document apply in ISO/GPS, unless otherwise indicated. For more detailed information on the relation of this document to other standards and the GPS matrix model, see Annex B for additional information. The estimated measurement uncertainty is to be taken into account when verifying conformity or nonconformity with specification. The problem arises when a measured value falls close to the upper or lower specification limit. In this case, verification of conformity or nonconformity with specifications is not possible: the measurement uncertainty induces a probability that a true value of the characteristic is out of specification even if the measured value falls inside the specification zone, or is in specification even if the measured value falls outside. Therefore, suppliers and customers should agree in advance in a method to resolve any issues that may arise. This document explains how to define default acceptance and rejection zones (i.e. decision rules) for verifying conformity or nonconformity with specifications. It is not the intentio

Scope: This document establishes the rules for verifying the conformity or nonconformity with a given tolerance for a characteristic of a workpiece (or a population of workpieces) or with a given maximum permissible errors for a metrological characteristic of a measuring equipment, including when the measured value falls close to the specification limits, taking measurement uncertainty into account. This document applies to specifications defined in general GPS standards (see ISO 14638), i.e. standards prepared by ISO/TC 213, including: — workpiece specifications and population specifications (usually given as an upper specification limit or a lower specification limit or both); — measuring equipment specifications (usually given as maximum permissible errors). This document only applies for characteristics and maximum permissible errors expressed as quantity values.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 14253-1-2017 PDF

ISO 14253-1-2017 PDF

$96.50 $193.00