ISO 14577-2-2026 PDF

ISO 14577-2-2026 PDF

Metallic materials-Instrumented indentation test for hardness and materials parameters-Part 2: Verification and calibration of testing machines

$96.50 $193.00 -50%
Product Code: ISO 14577-2 (2026)
Stock In Stock
Edition: 3.
Published: 06/2026
Number of Pages: 32
File Size: 1 file, 1.3 MB

Available Options

Product Description

Metallic materials — Instrumented indentation test for hardness and materials parameters — Part 2: Verification and calibration of testing machines

Introduction: Hardness has typically been defined as the resistance of a material to permanent penetration by another harder material. The results obtained when performing Rockwell, Vickers, and Brinell tests are determined after the test force has been removed. Therefore, the effect of elastic deformation under the indenter has been ignored. ISO 14577 (all parts)[2] has been prepared to enable the user to evaluate the indentation of materials by considering both the force and displacement during plastic and elastic deformation. By monitoring the complete cycle of increasing and removal of the test force, hardness values equivalent to traditional hardness values can be determined. More significantly, additional properties of the material, such as its indentation modulus and elasto-plastic hardness, can also be determined. All these values can be calculated without the need to measure the indent optically. Furthermore, by a variety of techniques, the instrumented indentation test allows to record hardness and modulus depth profiles within a, probably complex, indentation cycle. ISO 14577 (all parts) has been written to allow a wide variety of post test data analysis. Part 2 of ISO 14577 specifies the methods of verification and calibration of instrumented indentation testing machines. © ISO 2026 – All rights reserved

Scope: This document specifies the method of verification and calibration of testing machines for carrying out the instrumented indentation test in accordance with ISO 14577-1. It specifies a direct verification method for verifying and calibrating the main functions of the testing machine and an indirect verification method suitable for the determination of the repeatability of the testing machine. The methods in ISO 14577 are applicable to all systems that comply with the requirements of this part of ISO 14577.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 14577-2-2026 PDF

ISO 14577-2-2026 PDF

$96.50 $193.00