Metallic materials — Instrumented indentation test for hardness and materials parameters — Part 3: Calibration of reference blocks
Introduction: Hardness has typically been defined as the resistance of a material to permanent penetration by another harder material. The results obtained when performing Rockwell, Vickers, and Brinell tests are determined after the test force has been removed. Therefore, the effect of elastic deformation under the indenter has been ignored. ISO 14577 (all parts) has been prepared to enable the user to evaluate the indentation of materials by considering both the force and displacement during plastic and elastic deformation. By monitoring the complete cycle of increasing and removal of the test force, hardness values equivalent to traditional hardness values can be determined. More significantly, additional properties of the material such as its indentation modulus and elasto-plastic hardness can also be determined. All these values can be calculated without the requirement to measure the indent optically. Furthermore, by a variety of techniques, the instrumented indentation test allows to record hardness and modulus depth profiles within a, probably complex, indentation cycle. ISO 14577 (all parts) has been written to allow a wide variety of post test data analysis. © ISO 2026 – All rights reserved
Scope: This document specifies a method for the calibration of reference blocks to use for the indirect verification of testing machines for the instrumented indentation test as specified in ISO 14577-2. Reference materials, where it is necessary to prepare a surface before the test in a manner that removes surface layers are excluded from this standard.