ISO 14577-6-2025 PDF

ISO 14577-6-2025 PDF

Metallic materials-Instrumented indentation test for hardness and materials parameters-Part 6: Instrumented indentation test at elevated temperature

$96.50 $193.00 -50%
Product Code: ISO 14577-6
Stock In Stock
Edition: 1.
Published: 11/2025
Number of Pages: 28
File Size: 1 file, 2 Bytes

Available Options

Product Description

Metallic materials — Instrumented indentation test for hardness and materials parameters — Part 6: Instrumented indentation test at elevated temperature

Introduction: Hardness has typically been defined as the resistance of a material to permanent penetration by another harder material. The results obtained when performing Rockwell, Vickers, and Brinell tests are determined after the test force has been removed. Therefore, the effect of elastic deformation under the indenter has been ignored. ISO 14577 (all parts) has been prepared to enable the user to evaluate the indentation of materials by considering both the force and displacement during plastic and elastic deformation. By monitoring the complete cycle of increase and removal of the test force, hardness values equivalent to traditional hardness values can be determined. More significantly, additional properties of the material, such as its indentation modulus and elasto-plastic hardness, can also be determined. All these values can be calculated without the requirement to measure the indent optically. Furthermore, by a variety of techniques, the instrumented indentation test is able to generate hardness and modulus values at different indentation depths within the indentation cycle. This document has been prepared to enable the user to obtain hardness and other materials parameters using instrumented indentation testing at elevated temperature. The elastic and plastic properties of material components at elevated temperature are critical for determining the performance representative of in-service condition above ambient temperature. Typical applications include hard coatings, nuclea

Scope: This document specifies the instrumented indentation method for testing at elevated temperature for determination of hardness and other materials parameters at temperatures above ambient. Elevated temperature testing is defined in this document to be when the test piece and indenter tip are heated above the ambient conditions of the instrument to a controlled and measured temperature; insulating shielding is used to enclose the hot zone to reduce heating effects so that the majority of the instrumented indentation testing machine is at ambient conditions. This document is restricted to test machines that have been traceably calibrated and pass an indirect verification according to ISO 14577-2 when operating at elevated temperature to ensure that any effects on ambient sensors caused by the presence of a hot zone are accounted for. This document covers instrumented indentation testing at elevated temperatures in air, in inert or reducing gaseous environments, or in vacuum. This document provides a method for instrumented indentation testing at elevated temperature with both the indenter tip and test piece actively heated, and with independent feedback control and temperature measurement of both the indenter tip and test piece. This document provides a method for estimation of the uncertainty of the contact temperature. The uncertainty increases as the thermal conductivity of the test piece decreases. It is left to the user to decide if that uncertainty is fit for their purpose. The test method in this document is not applicable to: — instrumented indentation testing where there is no direct measurement of the temperature of the indenter tip body itself; — instrumented indentation testing where above ambient temperatures are obtained by placing the entire instrument in a hot box to achieve iso-thermal heating of the whole system. These systems typically only achieve limited elevated temperature; — instrumented indentation testing with active heating of the test piece but only passive heating of the indenter, e.g. by proximity to the hot test piece and thermal conduction through the indentation contact, hot gas, or any combination.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 14577-6-2025 PDF

ISO 14577-6-2025 PDF

$96.50 $193.00