Dispositifs de mesure de débit pour raccordement aux prises murales des systèmes de distribution de gaz médicaux
Introduction: Flow control devices are used to administer a prescribed flow of gas to a patient interface device (e.g. nasal cannula, facemask) from a pressure gas source, such as a medical gas supply system. These devices need to deliver accurate flows under varying conditions of temperature and inlet pressures. Therefore, it is important that the performance characteristics be specified and tested in a defined manner. Annex A provides additional insight into the reasoning that led to the requirements and recommendations that have been incorporated in this document. It is considered that knowledge of the reasons for the requirements will not only facilitate the proper application of this document but will expedite any subsequent revisions. © ISO 2023 – All rights reserved
Scope: 1.1 This document specifies requirements for flow control devices that can be connected by the user either directly, by means of a probe or a gas-specific connector, or indirectly by means of a low-pressure hose assembly conforming with ISO 5359 to: a) a terminal unit conforming with ISO 9170-1 of a medical gas pipeline system conforming with ISO 7396-1:2016; b) the pressure outlet of a regulator conforming with ISO 10524-1:2018; or c) to the pressure outlet of a valve integrated pressure regulator (VIPR) conforming with ISO 10524-3 (see 5.2 gas inlets). 1.2 This document applies to the following types of flow control devices (FCDs): a) flowmeters; b) flowgauge FCDs; and c) fixed orifice FCDs. NOTE Flow control devices that are classed as medical electrical equipment can be subject to additional requirements of IEC 60601-1. 1.3 This document applies to flow control devices for the following gases: — oxygen; — oxygen 93 %; — nitrous oxide; — medical air; — carbon dioxide; — oxygen/nitrous oxide mixture 50/50 (% volume fraction); — oxygen-enriched air; — helium; — xenon; and — specified mixtures of the gases listed above. NOTE Flow control devices can be available for other gases. 1.4 This document does not apply to flow control devices that are: a) for use with gases for driving surgical tools; b) an integral part of a regulator (see ISO 10524-1:2018); or © ISO 2023 – All rights reserved ISO 15002:2023(E) c) an integral part of a valve with integrated pressure regulator (VIPR) (see ISO 10524-3). 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 32, Gas cylinders for medical use — Marking for identification of content ISO 5359, Anaesthetic and respiratory equipment — Low-pressure hose assemblies for use with medical gases ISO 7396-1:2016, Medical gas pipeline systems — Part 1: Pipeline systems for compressed medical gases and vacuum ISO 9170-1:2017, Terminal units for medical gas pipeline