Plastics - Determination of caprolactam and its cyclic and linear oligomers by HPLC
Introduction: The method A specified in this document can be used for HPLC determination of the cyclic oligomers of caprolactam (n = 1) up to and including the hexamer (n = 6), using UV detection. If desired, after post- column reaction of the primary amine with 1,2-phthalic dicarboxaldehyde, online determination of the linear oligomers up to and including the hexamer can also be carried out. The determination is not quantitative for oligomers higher than the hexamer (n > 6). In the determination of cyclic oligomers the sensitivity for the tetramer and higher oligomers is constant, which means that calibration should take place up to and including the tetramer (n = 4). The linear oligomers are determined by the fluorescence of the iso-indole group, which is a product of the reaction between the primary amino group, 1,2-phthalic dicarboxaldehyde and 3 mercaptopropionic acid. The calibration with the linear oligomers should be carried out up to and including the hexamer (n = 6). The method B included in this document is intended for the determination of caprolactam and its cyclic dimer only, following the same principle and using the same equipment as method A, but significantly faster. © ISO 2018 – All rights reserved
Scope: This document describes a high-performance liquid chromatography (HPLC) method for determining the concentrations of cyclic oligomers of caprolactam, from 0,01 % by mass upwards, and linear oligomers of caprolactam, from 5 mg/kg upwards, both up to and including the hexamer of caprolactam (n = 6), in samples of polyamide 6, caprolactam and mixtures of rearrangement products in water. A second, significantly faster, HPLC method is included for determination of caprolactam and its cyclic dimer, based on the same principle and using the same equipment as the first method.