Road vehicles — Vehicle to grid communication interface — Part 21: Common 2nd generation network layer and application layer requirements conformance test plan
Introduction: Resulting from the 2nd generation network layer and application layer requirements for the vehicle to grid communication interface specified in ISO 15118-20, a corresponding set of abstract test cases is necessary to verify the conformance of implementations. Hence, this document specifies a conformance test suite for the 2nd generation network layer and application layer protocols to derive a common basis for conformance tests. The resulting test suite is a prerequisite for downstream interoperability tests. Since interoperability tests also involve the actual application logic of an implementation, such tests are beyond the scope of this document (see NOTE 1). Therefore, this document focuses on the communication interface aspects and the corresponding requirements given in ISO 15118-20 only. The layered structure of the conformance test documents with reference to ISO 15118-20 is shown in Figure 1. The complete set of relevant conformance test documents per charging type is composed of all the documents within its column according to Figure 1. Figure 1 — Overview of relevant conformance test plans for ISO 15118-20 per charging type EXAMPLE For a SUT supporting DC-charging, the following conformance test plan documents apply: — test plan for common network and application layer requirements (this document); — test plan for common security requirements; — test plan for AC-/DC-specific network and application layer requirements (only DC-specific subset applies). NOTE 1 Practi
Scope: This document specifies conformance tests in the form of an abstract test suite (ATS) for a system under test (SUT) that implements an electric-vehicle communication controller (EVCC) or a supply-equipment communication controller (SECC) for all common requirements specified in ISO 15118-20 that are independent of a particular charging type (AC, DC, ACD, WPT charging). These conformance tests specify the testing of capabilities and behaviours of an SUT, as well as checking what is observed against the conformance requirements specified in ISO 15118-20 and against what the implementer states the SUT implementation's capabilities are. The capability tests within the ATS check that the observable capabilities of the SUT are in accordance with the static conformance requirements specified in ISO 15118-20. The behaviour tests of the ATS examine an implementation as thoroughly as practical over the full range of dynamic conformance requirements specified in ISO 15118-20 and within the capabilities of the SUT. A test architecture is described in correspondence to the ATS. The abstract test cases in this document are described leveraging this test architecture and are specified in descriptive tabular format covering the ISO/ OSI layer 3 to 7 (network to application layers). In terms of coverage, this document only covers normative sections and requirements in ISO 15118-20. This document additionally refers to specific tests for requirements on referenced standards (e.g. IETF RFCs, W3C Recommendation, etc.) if they are relevant in terms of conformance for implementations according to ISO 15118-20. However, it is explicitly not intended to widen the scope of this conformance specification to such external standards, if it is not technically necessary for the purpose of conformance testing for ISO 15118-20. Furthermore, the conformance tests specified in this document do not include the assessment of performance nor robustness or reliability of an implementation. They cannot provide judgments on the physical realization of abstract service primitives, how a system is implemented, how it provides any requested service, or the environment of the protocol implementation. Furt