ISO 15592-3-2025 PDF

ISO 15592-3-2025 PDF

Fine-cut tobacco and smoking articles made from it-Methods of sampling, conditioning and analysis-Part 3: Determination of total particulate matter of smoking articles using a routine analytical smoking machine, preparation for the determination of water and nicotine, and calculation of nicotine-free dry particulate matter

$60.00 $120.00 -50%
Product Code: ISO 15592-3
Stock In Stock
Edition: 4.
Published: 06/2025
Number of Pages: 26
File Size: 1 file, 1 Byte

Available Options

Product Description

Tabac à rouler et objets confectionnés à partir de ce type de tabac - Méthodes d'échantillonnage, de conditionnement et d'analyse - Partie 3: Dosage de la matière particulaire totale des objets à fumer au moyen d'une machine à fumer analytique de routine, préparation pour le dosage de l'eau et de la nicotine, et calcul de la matière particulaire anhydre et exempte de nicotine

Introduction: Smokers make smoking articles by enclosing fine-cut tobacco in a suitable wrapper (sometimes incorporating a filter) either by hand or by using a rolling/tubing machine. The scientific literature has shown that the quantity of fine-cut tobacco, the type of wrapper chosen and the size of the articles made vary widely between consumers and between countries.[1] When the article is smoked, the yield of nicotine free dry particulate matter [NFDPM (sometimes referred to as “tar”)] and nicotine is determined by the construction of the article. This document has been developed to specify how articles are made in the laboratory and how they are tested. Fine-cut smoking articles made by consumers can therefore differ from the fine-cut smoking articles made for the purpose of testing described in this document. One smoking article is made using one mass of fine-cut tobacco and one tube made from a specified wrapper (see Annex A). It should be noted that because the use of fine-cut tobacco is so dependent on the way in which an individual makes a smoking article, a comparison of the smoke yield with the single result from factory-manufactured cigarettes according to ISO 4387 is of limited value. This document also gives further necessary procedures as follows in Annex B. © ISO 2025 – All rights reserved

Scope: This document specifies methods for the determination of total particulate matter in the mainstream smoke of fine-cut smoking articles (FCSAs) using a routine analytical smoking machine. It also specifies the preparation for the determination of water and nicotine, and calculation of nicotine-free dry particulate matter in the collected total particulate matter. This document specifies the method of making of fine-cut tobacco smoking articles using a tube made from a specified wrapper.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 15592-3-2025 PDF

ISO 15592-3-2025 PDF

$60.00 $120.00