ISO 15758-2014 PDF

ISO 15758-2014 PDF

Hygrothermal performance of building equipment and industrial installations - Calculation of water vapour diffusion - Cold pipe insulation systems

$71.50 $143.00 -50%
Product Code: ISO 15758
Stock In Stock
Edition: 2ND
Published: 05/01/2014
Number of Pages: 22
File Size: 1 file, 632 Bytes

Available Options

Product Description

Hygrothermal performance of building equipment and industrial installations - Calculation of water vapour diffusion - Cold pipe insulation systems

Introduction: If the thermal insulation of a cold pipe system is not completely water vapour tight, there will be a flow of water vapour from the warm environment to the surface of the pipe, whenever the temperature of the surface of the cold pipe is below the dew point of the ambient air. This flow of water vapour leads to an interstitial condensation in the insulation layer and/or dew formation on the surface of the pipe itself. Interstitial condensation may cause the insulation material to deteriorate and dew formation on the surface of a metal pipe may cause corrosion over time. If the temperature is below 0 °C ice will be formed and the methods of this standard will not apply. In period, when the dew point of the ambient air is higher than the temperature of the outer surface of the insulation, surface condensation will occur. This is dealt with in ISO 12241. Different measures are available to control water vapour transfer and reduce the amount of condensation. The following are normally applied: a) Installation of a vapour retarder; b) Use of insulation materials with a high water vapour resistance factor (low permeability); c) Use of a vapour retarder and a capillary active fabric to continuously remove condensed water from the pipe surface to the environment; see Annex B for an example. Which protection measure is chosen depends on the ambient climate, the temperature of the medium in the pipe and the water vapour diffusion resistance of the insulation layer. The success of any sy

Scope: This International Standard specifies a method for calculating the density of the water vapour flow rate in cold pipe insulation systems, and the total amount of water diffused into the insulation over time. The calculation method presupposes that water vapour can only migrate into the insulation system by diffusion, with no contribution from airflow. It also assumes the use of homogeneous, isotropic insulation materials so that the water vapour partial pressure is constant at all points equidistant from the axis of the pipe. This International Standard is applicable when the temperature of the medium in the pipe is above 0 °C. It applies to pipes inside buildings as well as in the open air.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 15758-2014 PDF

ISO 15758-2014 PDF

$71.50 $143.00