ISO 15876-1-2017 PDF

ISO 15876-1-2017 PDF

Plastics piping systems for hot and cold water installations - Polybutene (PB) - Part 1: General

$60.00 $120.00 -50%
Product Code: ISO 15876-1
Stock In Stock
Edition: 2ND
Published: 01/2017
Number of Pages: 16
File Size: 1 file, 417 Bytes

Available Options

Product Description

Plastics piping systems for hot and cold water installations - Polybutylene (PB) - Part 1: General

Introduction: The System Standard ISO 15876, of which this document is Part 1, specifies the requirements for a piping system when made from polybutene (PB). The piping system is intended to be used for hot and cold water installations. In respect of potential adverse effects on the quality of water intended for human consumption, caused by the product covered by ISO 15876 (all parts): — ISO 15876 (all parts) provides no information as to whether the product may be used without restriction in any of the Member States of the EU or EFTA; — it should be noted that, while awaiting the adoption of verifiable European criteria, existing national regulations concerning the use and/or the characteristics of this product remain in force. Requirements and test methods for material and components of the piping systems are specified in ISO 15876-2 and ISO 15876-3. Characteristics for fitness for purpose (mainly for joints) are covered in ISO 15876-5. ISO/TS 15876-7 gives guidance for the assessment of conformity. This document specifies the general aspects of the plastics piping system. At the date of publication of this standard, System Standards for piping systems of other plastics materials used for the same application include ISO 15874, ISO 15875, ISO 15876, ISO 15877, ISO 21003 and ISO 22391. © ISO 2017 – All rights reserved

Scope: This document specifies the general aspects of polybutene-1 (PB-1) piping systems intended to be used for hot and cold water installations within buildings for the conveyance of water whether or not intended for human consumption (domestic systems) and for heating systems, under design pressures and temperatures according to the class of application (see Table 1). The designation polybutene is used together with the abbreviation PB throughout this document. This document covers a range of service conditions (application classes) and design pressure and pipe dimension classes. Values of TD, Tmax and Tmal in excess of those in Table 1 do not apply. NOTE It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes. It also specifies the test parameters for the test methods referred to in this document. In conjunction with the other parts of ISO 15876, this document is applicable to PB pipes, fittings, their joints and to joints with components of other plastics and non-plastics materials intended to be used for hot and cold water installations.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 15876-1-2017 PDF

ISO 15876-1-2017 PDF

$60.00 $120.00