Indoor air — Part 24: Performance test for evaluating the reduction of volatile organic compound (except formaldehyde) concentrations by sorptive building materials
Introduction: Sorptive building materials have been marketed in the form of sheet and board products for removing airborne pollutants via physical sorption or chemical reaction. Harmonized test methods for evaluating sorptive effects are important for comparative assessment of the performance of sorptive building materials that are used for reducing levels of indoor air contaminants. This document specifies a test method for evaluating the performance of sorptive building materials for reducing indoor air volatile organic compound (VOC) concentrations over time. The performance of sorptive building materials is evaluated by measuring the area-specific reduction rate and the saturation mass per area and is affected by a number of factors. Specific test conditions are therefore defined in this document. This document can be applied to most sorptive building materials used indoors and for VOCs (excluding formaldehyde). This document is based on and is complementary to the test chamber method specified in ISO 16000-9. © ISO 2018 – All rights reserved
Scope: This document specifies a general laboratory test method for evaluating the reduction in concentration of VOCs by sorptive building materials. This method applies to boards, wallpapers, carpets, paint products, and other building materials. The sorption of those target compound(s), i.e. VOCs, can be brought about by adsorption, absorption and chemisorption. The performance of the material, with respect to its ability to reduce the concentration of VOCs in indoor air, is evaluated by measuring area-specific reduction rate and saturation mass per area. The former directly indicates material performance with respect to VOC reduction at a point in time; the latter relates to the ability to maintain that performance. This document is based on the test chamber method specified in ISO 16000-9. NOTE Sampling, transport and storage of materials to be tested, and preparation of test specimens, are described in ISO 16000-11. Air sampling and analytical methods to determine VOCs are described in ISO 16000-6 and ISO 16017-1.