Préservatifs en caoutchouc - Directives sur l'utilisation de l'ISO 4074 dans le management de la qualité des préservatifs en latex de caoutchouc naturel
Introduction: Condoms are medical devices used for contraception and for prevention of sexually transmitted infections. ISO 4074 is a quality standard for natural rubber latex condoms and ISO 23409 for condoms made from synthetic materials. They are reference documents for standardized end product quality test protocols and a baseline specification for critical attributes that affect condom safety and effectiveness. They are applied by manufacturers, procurement agencies, regulatory bodies and testing laboratories. The use of ISO 4074 and or ISO 23409 does not by itself ensure consistency in quality; consistent high quality at the lowest possible cost is attained only through a regime termed quality management, through which, quality is built into the product and ensured at every point in the design, planning, production and procurement processes. This document should lead to continuous improvement in manufacturing, procurement and testing processes. The special requirements of buyers and consumers should also be given due consideration when applying ISO 4074 or ISO 23409, as ISO 4074 and ISO 23409 are general by design, and will not cover all circumstances completely. This document provides guidance to manufacturers, buyers and third-party test laboratories on implementing and applying ISO 4074 in the manufacture of condoms, and to purchasers on applying ISO 4074 or ISO 23409 and verifying that the condoms delivered conform to the specification, as appropriate. Acceptable condoms meet or
Scope: This document provides guidance on using ISO 4074 and ISO 23409 and addresses quality issues to be considered during the development, manufacture, quality verification and procurement of condoms. It encompasses the aspects of quality management systems in the design, manufacture and delivery of condoms with an emphasis on performance, safety and reliability. Male condoms are either made from essentially natural rubber latex, in which case the requirements of ISO 4074 are applicable, or from synthetic materials and/or blends of synthetic materials and natural rubber latex, in which case the requirements of ISO 23409 are applicable. This document outlines the aspects applicable to both types of condoms with specific clarifications where appropriate.