ISO 16049-1-2020 PDF

ISO 16049-1-2020 PDF

Air cargo equipment-Restraint straps-Part 1: Design criteria and testing methods

$96.50 $193.00 -50%
Product Code: ISO 16049-1
Stock In Stock
Edition: 3RD
Published: 01/2020
Number of Pages: 30
File Size: 1 file, 1 Byte

Available Options

Product Description

Air cargo equipment — Restraint straps — Part 1: Design criteria and testing methods

Introduction: This document specifies the design criteria and testing methods applicable to air cargo restraint straps to be used for tie-down of unitized or non-unitized cargo on board civil transport aircraft. Throughout this document, the minimum essential criteria are identified by use of the key word "shall". Recommended criteria are identified by use of the key word "should" and, while not mandatory, are considered to be of primary importance in providing safe restraint straps. Deviation from recommended criteria should only occur after careful consideration, extensive testing, and thorough service evaluation have shown alternate methods to be satisfactory. The requirements of this document are expressed in the applicable SI units, with approximate inch- pound units conversion between brackets for convenience in those countries using that system. © ISO 2020 – All rights reserved

Scope: This document specifies the design criteria and testing methods adequate to guarantee the ultimate load and operational dependability of cargo restraint strap assemblies with a typical 22 250 N (5 000 lbf) rated ultimate tension load capability, as used by the airline industry. These restraint straps are used in civil transport aircraft during flight for: a) cargo loaded and tied down onto airworthiness approved air cargo pallets, themselves restrained into aircraft lower deck, main deck or upper deck cargo systems and meeting the requirements of ISO 8097 (NAS 3610) or ISO 21100, or b) non unitized individual pieces of cargo, or pieces of cargo placed onto an unrestrained ("floating") pallet into either lower deck, main deck or upper deck containerized cargo compartments of an aircraft, c) the same restraint strap assemblies can also be used in other applications such as: 1) non containerized (bulk loaded) baggage and cargo compartments; 2) to ensure cargo restraint inside an airworthiness approved air cargo container. NOTE The ultimate loads allowable on the attachment points available in most aircraft bulk compartments and inside many air cargo containers are significantly lower than 22 250 N (5 000 lbf). This results in the restraint arrangements ultimate load capability being dictated by the weakest element, i.e. the attachment points: typical 22 250 N ultimate load restraint straps will therefore be in excess of the requirements for such applications. Compliance with this document provides one means of cargo restraint straps airworthiness approval by Civil Aviation Authorities under TSO/ETSO-C172a, in addition to the other requirements therein.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16049-1-2020 PDF

ISO 16049-1-2020 PDF

$96.50 $193.00