Air cargo equipment — Restraint straps — Part 2: Utilization requirements and recommendations and lashing calculations
Introduction: This document specifies utilization guidelines and the principles to be used in tie-down/lashing strength calculations for the use of air cargo restraint straps on board civil transport aircraft. The civil aviation requirements referred to in the present document are those relating to operation of transport aircraft. They constitute the set of operation requirements internationally agreed in application of International Civil Aviation Organization (ICAO) Annex 6, Operation of aircraft, to the Convention on International Civil Aviation. Throughout this document, the minimum essential criteria are identified by use of the key word “shall”. Recommended criteria are identified by use of the key word “should” and, while not mandatory, are considered to be of primary importance in providing safe lashing arrangements. Deviation from recommended criteria should only occur after careful consideration and thorough service evaluation have shown the alternate methods ensure the same level of safety. The requirements of this document are expressed in the applicable SI units, with approximate inch- pound units conversion between brackets for convenience in those countries using that system. © ISO 2020 – All rights reserved
Scope: This document aims at providing general utilization requirements and recommendations and calculation methods adequate to guarantee the effectiveness and ultimate load strength of tie-down/ lashing arrangements performed to restrain cargo on board civil transport aircraft during flight: a) cargo loaded and tied down onto airworthiness approved air cargo pallets, themselves restrained into aircraft lower deck or main deck or upper deck cargo systems meeting the restraint requirements of air cargo pallets approved in accordance with ISO 8097 (NAS3610) or ISO 21100, or b) additional tie-down on aircraft structure when necessitated by pallet maximum gross mass or centre of gravity limits, or c) non-unitized individual pieces of cargo, or pieces of cargo placed onto an unrestrained (“floating”) pallet into either lower deck, main deck or upper deck containerized cargo compartments of an aircraft, or d) individual pieces of load loaded in non-containerized (bulk loaded) baggage or cargo compartments. This document applies to cargo tie-down/lashing arrangements using exclusively air cargo restraint straps conforming to ISO 16049-1. Its general recommendations may also be used for tie-down arrangements using other means (e.g. steel cables, rope, other types of straps), but under the user’s responsibility as to their adequacy and the strength calculations required. NOTE 1 Where tie-down is performed onto aircraft structure as per b) or c) above, additional restrictions can be stated in the aircraft's Authority approved Weight and Balance Manual. NOTE 2 The use of chains, rods, or other rigid devices for tie-down onto civil transport aircraft floor tracks, which can generate excessive stress in the aircraft structure, is not part of the scope of this document. . This document aims at providing industry recognized means of complying with Airworthiness Authorities general requirements applicable to load securing on board civil transport aircraft (see CCAR-25, JAS Part 3, 14 CFR Part 25 and EASA CS-25), and aircraft manufacturers Authority approved Weight and Balance Manuals for each aircraft type as specified therein. It is not the intent of this document to specify when res